Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DU1000CGQ2

DU1000CGQ2 Whirlpool Dishwasher - Overview

Get Parts and Repair Help for DU1000CGQ2

If you know the dishwasher repair part you need, you can browse the list of all parts on the DU1000CGQ2, or you can search by name or part description. You can also find your part by where it is located on the DU1000CGQ2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for DU1000CGQ2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.44

Upper Spray Arm Mount

**Please note: This is a redesigned part. The top mounting clip and screw are no longer needed.

$13.96

Wash Arm Bearing Ring

This part will fit between the newer type lower wash arm and the wash arm retainer nut of your dishwasher.

$6.11

Seal, Lower Sprayarm

This dishwasher lower spray arm seal, or under spray arm bearing ring, is designed with the split by the manufacturer. It is not damaged or defective, and is sourced directly from ...

$4.48

Lower Sprayarm Nut

This spray arm nut is used in dishwashers and works as the retaining nut for the lower dishwasher spray arm. The nut makes sure the lower spray arm is secured to the pump housing. If your spray arm is coming off, or your nut is lost or damaged, replacing the part can be a solution to your problem. Remember to unplug dishwasher from power source and disconnect the water supply before you begin this installation. Refer to the manual provided by the manufacturer for further installation instructions.

$46.06

Door Gasket - Gray

This gasket wraps around the sides and top of the dishwasher door and helps seal the door when it is closed to prevent water from leaking from the dishwasher during the washing cyc...

$3.02

Spring, Lid

The dishwasher lid spring helps open the dispenser cover in the soap box when the control releases the latch. If your dishwasher does not dispense detergent, is broken and worn out, or the door is not opening properly, replacing the dispenser spring could be the solution. For this replacement you will need needle nose pliers. First, release the cover on the detergent dispenser, then remove the cover from the shaft it hinges on. Pull the shaft from one side and remove the spring from the shaft. Next, replace with the new spring and engage the two open hooks into the soap cover. Finally, grasp the hook and pull it over tab on the side of the wash cup. Verify that it works properly by opening and closing the cap. Refer to the manual provided by the manufacturer for further instructions.

$4.89

Rubber Washer

The rubber washer is a part which is specific to dishwashers and should not be substituted by a similar part. It works with the heating element to seal the receptacle opening where...

$44.38

Drain and Wash Impeller Kit

This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper, and installation screw. This part helps stop your dishwasher from leaking and helps with the proper draining of the dishwasher. If you notice that your dishes are not cleaning, the dishwasher is not draining properly, or is making any unusually loud sounds or grinding noises, this could indicate the impeller and seal kit have broken down and need to be replaced. You will need a #15 and #20 torx driver, a small flat-blade screwdriver, 1/4-inch nut driver, adjustable wrench, and a small hammer and a sharp chisel.

$17.63

High Limit Thermostat

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating eleme

$5.36

Pin (Lid Hinge)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dishes not clean and lower wash arm wobbled.

  • Customer: James from Jacksonville, FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 547 of 556 people found this instruction helpful
Completely removed lower wash arm and replaced bearing ring and seal. read more

Not Cleaning lightly soiled items.

  • Customer: Dennis from Cromwell, CT
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 376 of 379 people found this instruction helpful
Removed spray arm thumb nut. Removed spray arm. replaced worn and broken earings and re-assembled in reverse order. Would have done the repair a lot sooner if I had known that PartsSelect was just a few miles up the highway. read more

Dishwasher leaking at bottom of door

  • Customer: Eileen from Salt Lake City, UT
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 169 of 174 people found this instruction helpful
Installed new door seal. Dishwasher still leaked. Googled the model number and then cleaned the filter at the bottom of the dishwasher, still leaked.
Verified that manifold bearing was not work. It was OK.
Found note that a plugged vent might cause leaking door. Very counterintuitive. Pried off air vent cover. Vent was thouroughly plugged wit... read more