Models > DTS18ZBRJRWW

DTS18ZBRJRWW General Electric Refrigerator - Overview

Get Parts and Repair Help for DTS18ZBRJRWW

If you know the refrigerator repair part you need, you can browse the list of all parts on the DTS18ZBRJRWW, or you can search by name or part description. You can also find your part by where it is located on the DTS18ZBRJRWW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for DTS18ZBRJRWW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$2.79

Evaporator/Condensor Fan Grommet

$1.48

Compression Ring

$20.09

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$33.70

Light Switch

$4.05

Condenser Fans Blade Assembly

$48.48

Lower Crisper Pan

Also known as 1/2 pan.

$3.00

Hinge Washer

$2.36

SCR 10-16 AB PNT20 1/2 S

$7.27

Evaporator Fan Blade

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 28 of 32 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more

Freezer coils icing up, fridge too warm

  • Customer: Tim from West Palm Beach FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 16 of 18 people found this instruction helpful
Had to remove inside panels to expose coils in freezer. Used hair dryer and towels to de-ice. Reading online learned about defrost heater (long thin glass tube with wire coil in it I could not see b/c up under the inside of the coils). Who would have guessed freezers have heaters in them!! And learned the defrost timer (inside the fridge) is just a continuou... read more

My fridge and freezer were not getting cold enough.

  • Customer: Marcus from SLC UT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 13 of 14 people found this instruction helpful
The Fridge and freezer were not very cold except for in the very back of the freezer (where the coils are). So I opened up the back of the freezer by first removing the dome light cover and removing all the visible screws. I then lifted up and pulled out the vent in the center of the back panel and removed the two remaining screws on the back panel. At that ... read more