Models > DTS18ICSVRBB

DTS18ICSVRBB General Electric Refrigerator - Overview

Get Parts and Repair Help for DTS18ICSVRBB

If you know the refrigerator repair part you need, you can browse the list of all parts on the DTS18ICSVRBB, or you can search by name or part description. You can also find your part by where it is located on the DTS18ICSVRBB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for DTS18ICSVRBB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$3.00

Evaporator/Condensor Fan Grommet

$3.28

SWITCH LIGHT

$1.57

Compression Ring

$20.75

Single Outlet Valve Kit

This single outlet valve has 1/4 inch compression fittings, and is intended for use with refrigerators that have ice makers that make crescent shaped ice cubes. NOTE: As per the m...

$4.29

Condenser Fans Blade Assembly

$11.95

Dairy Door

$10.89

BUCKET ICE

$2.57

SCR 10-16 AB PNT20 1/2 S

Sold Individually.

$7.89

Evaporator Fan Blade

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 45 of 50 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more

Freezer coils icing up, fridge too warm

  • Customer: Tim from West Palm Beach FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 21 of 23 people found this instruction helpful
Had to remove inside panels to expose coils in freezer. Used hair dryer and towels to de-ice. Reading online learned about defrost heater (long thin glass tube with wire coil in it I could not see b/c up under the inside of the coils). Who would have guessed freezers have heaters in them!! And learned the defrost timer (inside the fridge) is just a continuou... read more

not making ice

  • Customer: thomas from richmond VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 21 of 24 people found this instruction helpful
when the ice maker runs through its cycle, you should be able to hear the solinoid valve open, letting water into the ice maker. this was not happening for me. you can dissconnect the plug on the valve and put the two probes from a multimeter in the plug and set for AC volts. when the ice maker runs its cycle, at the end you should see the meter jump as pow... read more