Models > DTS18ICRJRBB

DTS18ICRJRBB General Electric Refrigerator - Overview

Get Parts and Repair Help for DTS18ICRJRBB

If you know the refrigerator repair part you need, you can browse the list of all parts on the DTS18ICRJRBB, or you can search by name or part description. You can also find your part by where it is located on the DTS18ICRJRBB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for DTS18ICRJRBB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$3.00

Evaporator/Condensor Fan Grommet

$3.28

SWITCH LIGHT

$1.57

Compression Ring

$20.75

Single Outlet Valve Kit

This single outlet valve has 1/4 inch compression fittings, and is intended for use with refrigerators that have ice makers that make crescent shaped ice cubes. NOTE: As per the m...

$21.14

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$4.29

Condenser Fans Blade Assembly

$11.95

Dairy Door

$10.89

BUCKET ICE

$2.57

SCR 10-16 AB PNT20 1/2 S

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 45 of 50 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more

Freezer coils icing up, fridge too warm

  • Customer: Tim from West Palm Beach FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 21 of 23 people found this instruction helpful
Had to remove inside panels to expose coils in freezer. Used hair dryer and towels to de-ice. Reading online learned about defrost heater (long thin glass tube with wire coil in it I could not see b/c up under the inside of the coils). Who would have guessed freezers have heaters in them!! And learned the defrost timer (inside the fridge) is just a continuou... read more

water appearing under refrigerator

  • Customer: Larry from Dallas TX
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers, Wrench set
  • 20 of 22 people found this instruction helpful
Unplugged the refrigerator and turned off the water to the ice maker valve. Removed the water line at both ends (small crescent wrench). Removed the cover from the water valve area (two Phillips head screws). Removed the valve (two screws - small nut driver) and pulled off the two electrical connections.

Installed the new valve with the reverse pr... read more