DP400PD1 Uni Dishwasher - Instructions

Removed front toe kick plate, removed elect.wire, Lifted heating element up replaced old gromet seal put element back through tub put new not on the element and tighetend up with One half inch deep socket ,Replaced plastic wire cover over element spade conector replaced electric wire on to element. Start machine checked r leak, replace toe kick plate.......... Done

power off, take off kickplate, unplug 2 wires and unscrew broken nuts, put new nuts on, plug wires back in,(run dishwasher one cycle to make sure no leaks) put kickplate back on, power on.

Ditto the other comments. Easy, great savings. Perfect. Thank you!

first I shut off power at breaker then took off bottom panel,removed old nuts had a problem with the 1 in the back had to remove a few wires to be able to reach in.Then i open door removed dishwasher rack and heater element notice that the hole was rusted out a little so I cleaned area up and used permatex silicone all the area installed the new grommets replaced the heating element put it all back together will test for leaks after silicone cures

This dishwasher has a plastic bolt that holds the actuator on. The action loosens the bolt and it wobbles and eventually comes off. After enough attempts the bolt will strip and need to be replaced. I took some 3M loctite this time to hold it in place. It is 24 years old, but still kicking

Spotted the source of the leak at the first heating element under the dishwasher. Removed the brass mounting nut and it was cracked. Replaced with new part from PartSelect.com and the leak was fixed. Apparently the heating element gets so hot it tends to crack the mounting nuts, which results in a leak. Delivery time for part said 3-5 days - mine arrived one day after ordered!