Models > DP3880XMW0

DP3880XMW0 Whirlpool Dishwasher - Overview

Get Parts and Repair Help for DP3880XMW0

If you know the dishwasher repair part you need, you can browse the list of all parts on the DP3880XMW0, or you can search by name or part description. You can also find your part by where it is located on the DP3880XMW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for DP3880XMW0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.96

Rubber Washer

Sold individually. Used with the heating element.

$3.51

Lid Spring

This metallic spring is for your dishwasher's soap cup cover.

$23.40

Faucet Adapter

Used with some portable dishwashers and washers. NOTE: As per the factory, this is used for faucets with inside or outside threads. For female connection (outside) just remove t...

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$5.54

Touch-Up Paint - White

$2.70

Screw - 8-18 x 1/2

Sold Individually.

$20.34

Detergent Dispenser Cover Kit

This kit also includes the lid hinge pin, spring, snap and latch.

$2.70

Cover Screw

Sold individually.

$144.23

Upper Dishrack Kit

The dishrack kit comes with the dishrack, rollers, adjustable tines, and clips. Must be assembled. Note: This part has been redesigned by the manufacture. Blue is no longer available. White only.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dishwasher Not Draining

  • Customer: Lewis from Portsmouth NH
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 85 of 119 people found this instruction helpful
Ordered both drain & wash impeller kit and the drain check valve with o-ring. Decided to test the cheaper drain check valve first. Pulled dishwasher out from wall & adjacent cabinetry; removed drain hose from disposer and drained as much water as possible; "jacked" side of dishwasher to gain access to drain hose and drain check valve; used pliers to remove ... read more

Hummed when start button was pushed.

  • Customer: Bob from Thayer KS
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Wrench set
  • 24 of 30 people found this instruction helpful
Safety first, so unplug the dryer. Next remove the two phillips head screws @ lower left and right front corners and take the front panel off. You will have to disconnect the door switch sensor wires which are yellow and white, marking the sensor so you can replace correctly. Next remove the front tumbler assembly with 4 screws, two on each side. Be sure to ... read more

Tines were broken and rack was damaged

  • Customer: Dennis from Littleton CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 33 of 57 people found this instruction helpful
Replaced the dish rack.

Removed the retaining clips on the front of the rail and removed the old rack.

Removed the spray arm assembly from the old rack.

Assembled the new rack, with the supplied parts from the kit. Using the old rack to know where some parts needed to be placed.

Put the spray arm assembly on the... read more