Models > DNT18F9L-A

DNT18F9L-A (5B41B) Admiral Refrigerator - Overview

Get Parts and Repair Help for DNT18F9L-A

If you know the refrigerator repair part you need, you can browse the list of all parts on the DNT18F9L-A, or you can search by name or part description. You can also find your part by where it is located on the DNT18F9L-A by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DNT18F9L-A [Viewing 1 of 1]

$3.96

Door Shelf Trim Retainer

$4.46

TRAY-EGG

$3.83

Screw

Sold individually.

$47.73

Door Shelf Retainer Bar - Cut to Fit

This cut-to-fit refrigerator door shelf retainer bar may be longer than orginal, cut to size needed.

$2.70

RETAINER

$103.26

Fresh Food Door Gasket

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$16.38

Hinge Pin Bushing

This bushing is to be used with a 1/4 inch pin.

$9.24

BUTTERTRAY

$93.57

Freezer Door Gasket

This white freezer door gasket is used to seal the freezer door when closed to keep the cool air inside and the room air out.

$2.70

Screw

Sold Individually.

Common Symptoms of the DNT18F9L-A [Viewing 1 of 17]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

failure to seal fridge doors adequately.

  • Customer: Joel from Upper Arlington OH
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Socket set
  • 8 of 11 people found this instruction helpful
The doors had many hex screws. Using the correct socket size was critical. Empty the door shelves first. The screws had to come out because the new seal had slot holes for them to go between. Take off half of the screws from the top and sides and partially remove the old seal. Attach the new seal and do the same with the bottom half. With the new seal on the... read more

Needed to replace gasket/seal on fridge

  • Customer: Nancy from Malden MA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 5 of 5 people found this instruction helpful
MOST IMPORTANTLY MAKE SURE YOU GET THE WRINKLES OUT OF THE GASKET, A STEP WE DID NOT FOLLOW EXACTLY, SO WE ENDED UP HAVING TO WORK THE SEAL A LOT MORE TO MAKE IT FIT PROPERLY WHICH OF COURSE MADE THE REPAIR TAKE LONGER THAN NEEDED. OTHER THAN THAT NO PROBLEMS HERE read more

Gasket wouldn't seal all the way around

  • Customer: Thomas from Mobile AL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 4 of 4 people found this instruction helpful
Due to some deformity of the gasket, it didn't seal all the way around. The instructions suggested using a heat light to warm the gasket with the door open. That didn't work too well so I closed the door and used a heat gun lightly in the areas it didn't seal. That worked great to soften the gasket so the magnet in the gasket could pull it gasket tight to t... read more