Models > DLL2880BAC

DLL2880BAC Hotpoint Dryer - Overview

Get Parts and Repair Help for DLL2880BAC

If you know the dryer repair part you need, you can browse the list of all parts on the DLL2880BAC, or you can search by name or part description. You can also find your part by where it is located on the DLL2880BAC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DLL2880BAC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DLL2880BAC [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

D-Shaped Knob Insert Clip

Sold individually.


Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running as smoothly as possible with as little noise as possible.



This part helps to keep the door closed while the machine is running.


Adjustable Leveling Screw


Rear Drum Bearing

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.


Door Switch

This part has three terminals. Note: Use the two smaller terminals for models that only have two wires to the switch.


Idler Pulley Wheel

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.


Gas Igniter

Be very careful to not handle the igniter by its gray part. Hold it by its white tip only.



This screw is sold individually.


Blower Wheel

This wheel attaches to the motor.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Squeaking Dryer - Rear Drum bearing gone bad

  • Customer: Jason from Cary NC
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers, Socket set
  • 27 of 30 people found this instruction helpful
First, I loosened the the top control panel and then loosened the top flat roof panel which allowed me access to the inside of the dryer. Then, I removed the front panel which allowed access to the drum. I was amazed at the amount of lint that was inside the dryer itself. Most of my time was spent in the disassembly and cleaning of the internal cavity around... read more

Gas dryer heat would not come on

  • Customer: Jeff from Seattle WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Wrench set
  • 30 of 40 people found this instruction helpful
Unplugged dryer, opened lower panel. Loosened the bolt that holds igniter assembly to gas unit and removed old igniter. Put new igniter in the pinch clamp then (being VERY careful so as not to crack new part) replaced igniter assembly and tightened its bolt firmly. Voilà, ignition! read more

Dryer squeaked when running

  • Customer: Mark from Garrett IN
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 23 of 32 people found this instruction helpful
Everything is cleaned as it is removed.

Remove the two screws holding the top down.
Disconnect two wires from door switch.
Remove the two hex screws holding the front on.
Remove the 4 screws holding the access panel on the back and disengage idler pulley to loosen the belt.
Remove the drum.
Label the wires then remove the ... read more