Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DLL1550BGL > Parts

DLL1550BGL Hotpoint Dryer - Parts

All parts for the Hotpoint Dryer DLL1550BGL

Below is a list of all parts for the Hotpoint Dryer DLL1550BGL - Residential Gas. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the DLL1550BGL
1-14 of 163
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.54

D-Shaped Knob Insert Clip

This clip ensures that the knob is securely fastened to the control shaft, allowing you to properly select the correct time and setting for your dryer. If your dryer will not start...

$51.71

Rear Drum Bearing Kit

This rear drum bearing kit includes a shaft, ground strap, bearing, seven screws, and installation instructions. The bearing plate comes with a slot in it for the ground strap. This part helps keep your dryer running as smoothly as possible with as little noise as possible by supporting the back of the dryer drum and reducing friction as the drum rotates. Over time, your drum bearing will wear out, cause your dryer to be noisy, and you will have to replace it. There may be some sharp internal parts, so be sure to wear work gloves during repair.

$10.23

Drive Belt

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

$3.71

LATCH DOOR

This door latch is designed for your dryer, and is mounted to the dryer frame. The door latch holds the door of your dryer closed while the machine is operating. If your dryer door is not catching on the door strike, and will not stay closed, you may need to replace the door latch. This part is square in shape, and is approximately 3/4-inch in length, by 3/4-inch in width. The part is made of white plastic with a metal tab. To access the door latch, you will need to remove the top and side panels on your dryer. To complete this repair, simply pop the damaged door latch out of position, and snap the new one into place.

$13.64

Lint Filter with Frame

$4.63

Adjustable Leveling Screw

$29.83

'M' Series Primary Dual Coil Gas Valve

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

$2.06

Screw

This screw is sold individually.

$24.61

'M' Series Secondary Coil - 2 Terminals

$5.06

Rear Drum Bearing

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

$27.04

Front Drum Slide Kit

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

$21.46

Gas Igniter

Be very careful to not handle the igniter by its gray part. Hold it by its white tip only.

$9.35

Idler Pulley Wheel

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$140.02

Drive Motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

All Parts for the DLL1550BGL
1-14 of 163