Models > DLG2524W

DLG2524W LG Dryer - Overview

Get Parts and Repair Help for DLG2524W

If you know the dryer repair part you need, you can browse the list of all parts on the DLG2524W, or you can search by name or part description. You can also find your part by where it is located on the DLG2524W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$21.75

Drum Support Roller

This part is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. It is recommended that you replace both rollers at once. Sold Indiv...

$25.79

Lint Filter

This part has the felt strip and is used to collect lint as it passes through the dryer vent.

$10.52

Thermistor,NTC

$4.59

Thermostat

$3.05

Sensor

$22.86

Poly-V Drive Belt

$17.02

Cover,Guide

$10.52

Thermostat

$8.18

Thermostat Assembly

$47.18

Gas Igniter

Comes with bracket and wire harness.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Gas Dryer not getting hot

  • Customer: Terry from Goose Creek SC
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 9 of 12 people found this instruction helpful
I noticed the flame would start, then quit after about 15 seconds. I checked the flame detector, and found the lenze cracked. I replaced it, and it's as good as gold.

It looked like a hard job to take the drum out to get at the part. But the top was off with 3 screws, the front about 6 I think. Then the front frame, only 4 screws. I think sett... read more

Shutting off a while after starting. Burning smell.

  • Customer: Dennisd from Waco TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
Seemed to be shutting off on the safety thermostat so I replaced them all. Works. read more

I broke the igniter while adapting from Natural gas to LPG

  • Customer: Nathan from Mount Vernon WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
This was a repair from a repair. It started as a conversion to LPG, in the process the igniter broke. The parts arrived quickly and we were able to get it back together and the wife is happy. Thanks. read more