Models > DH50M-01

DH50M-01 Magic Chef Dehumidifier - Overview

Get Parts and Repair Help for DH50M-01

If you know the dehumidifier repair part you need, you can browse the list of all parts on the DH50M-01, or you can search by name or part description. You can also find your part by where it is located on the DH50M-01 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DH50M-01 [Viewing 3 of 3]

$2.70

Screw

This screw is sold individually.

$37.05

Condensor Fan Blade - Black

This blade comes with a retaining clip and screw.

Fan Blade Locking Clip

This fan blade locking clip is well under an inch long, and is made of metal.

HUMIDISTAT

$71.20

MOTOR- FAN

SWITCH, OVERFLOW CONTROL

THERMOSTAT

USE WPL 61006030

CASTER

$3.83

CLIP- COMP

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The old blade separated from the shaft.

  • Customer: William from Oriskany NY
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 1 of 1 people found this instruction helpful
Removed all screws from the outside case, then I had access to the motor. Removed 4 screws from the bracket holding the motor assembly in place, removed it from the case. Next I pulled off the broken fan part, installed the new blade and secured it with the supplied bracket. Next I installed the motor assembly in reverse with the 4 screws I removed earlie... read more

Fan motor not operating correctly--difficuft to turn by hand.

  • Customer: Jeff from Highland MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
(1) Compared old an new motors to ensure compatability. (2) Removed old motor from frame. (3) Mounted new motor to frame. This was the easy part...took a couple of minutes. The tricky part was the wiring--because of how the original motor had been wired into the appliance, I ended up splicing the new motor wires into the old motor end-clips (left them co... read more