Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DH40L

DH40L Crosley Dehumidifier - Overview

Get Parts and Repair Help for DH40L

If you know the dehumidifier repair part you need, you can browse the list of all parts on the DH40L, or you can search by name or part description. You can also find your part by where it is located on the DH40L by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DH40L

[Viewing 2 of 2]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

Screw

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this sc...

Order within the next 4 hrs and your part ships today!
$12.65

Palnut

This palnut is designed for use in cooktops, ranges, wall ovens, dehumidifiers, and range hoods. The palnut is screwed onto a bolt on top of an ordinary nut, and locks the nut in place when the nut is tightened. This product is made of metal, and is approximately 1/2-inch in diameter. This product is sold individually. This is an OEM part sourced directly from the manufacturer. Be sure to disconnect power to the appliance before you begin this repair.

Order within the next 4 hrs and your part ships today!
$44.00

Condensor Fan Blade - Black

This fan blade is used with some dehumidifiers. At just under 10 inches long, it is black and comes with a retaining clip and screw. This part may bend or break over time and will ...

Order within the next 4 hrs and your part ships today!

HUMIDISTAT

$140.63

MOTOR- FAN

SWITCH, OVERFLOW CONTROL

THERMOSTAT

USE WPL 61006030

CASTER

$6.84

CLIP- COMP

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The old blade separated from the shaft.

  • Customer: William from Oriskany, NY
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 1 of 1 people found this instruction helpful
Removed all screws from the outside case, then I had access to the motor. Removed 4 screws from the bracket holding the motor assembly in place, removed it from the case. Next I pulled off the broken fan part, installed the new blade and secured it with the supplied bracket. Next I installed the motor assembly in reverse with the 4 screws I removed earlie... read more

Fan motor not operating correctly--difficuft to turn by hand.

  • Customer: Jeff from Highland, MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
(1) Compared old an new motors to ensure compatability. (2) Removed old motor from frame. (3) Mounted new motor to frame. This was the easy part...took a couple of minutes. The tricky part was the wiring--because of how the original motor had been wired into the appliance, I ended up splicing the new motor wires into the old motor end-clips (left them co... read more