Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DH40K

DH40K Maytag Dehumidifier - Overview

Get Parts and Repair Help for DH40K

If you know the dehumidifier repair part you need, you can browse the list of all parts on the DH40K, or you can search by name or part description. You can also find your part by where it is located on the DH40K by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DH40K

[Viewing 2 of 2]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

Screw

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this sc...

$44.00

Condensor Fan Blade - Black

This fan blade is used with some dehumidifiers. At just under 10 inches long, it is black and comes with a retaining clip and screw. This part may bend or break over time and will need to be replaced. If the fan blade is not working you will not hear the fan blowing air across the coils when it is turned on. This could cause the dehumidifier to freeze up. You will need to remove the front panel and take the motor out to access this part. This is an OEM part that comes right from the manufacturer.

HUMIDISTAT

SWITCH, OVERFLOW CONTROL

FAN MOTOR

THERMOSTAT

USE WPL 61006030

CASTER

$6.84

CLIP- COMP

GROMMET

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The old blade separated from the shaft.

  • Customer: William from Oriskany, NY
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 1 of 1 people found this instruction helpful
Removed all screws from the outside case, then I had access to the motor. Removed 4 screws from the bracket holding the motor assembly in place, removed it from the case. Next I pulled off the broken fan part, installed the new blade and secured it with the supplied bracket. Next I installed the motor assembly in reverse with the 4 screws I removed earlie... read more