Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DH40J0 > Parts

DH40J0 Whirlpool Dehumidifier - Parts

All parts for the Whirlpool Dehumidifier DH40J0

Below is a list of all parts for the Whirlpool Dehumidifier DH40J0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the DH40J0
1-14 of 59
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.75

Hex Nut

This hex nut is an authentic Whirlpool part that is sourced directly from the original equipment manufacturer, and will fit a variety of appliances including ovens, microwaves, ref...

$3.02

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

$4.12

Float

If the bucket is full indicator on your dehumidifier is on but the bucket is empty, you may have a problem with the float. If you notice that the float is warped or damaged, it sho...

$4.89

TIE-WIRE

$62.66

Bucket and Float Kit

This bucket and float kit, also known as water tank assembly, is for a dehumidifier is 14.5 inches long and 8.5 inches wide. The water tank extracts, traps, and contains the moistu...

$4.69

Float Clip

The float clip works in a humidifier to ensure the float functions properly. The float is located near the humidifier bucket and monitors the water level as it rises and the clip keeps it in place. The float makes sure the water level is balanced and does not over flow. This float triggers the flow switch to shut off. If there is a defect with the clip, it can be a safety hazard as it might not be able to detect and stop an overflow. Make sure to unplug the dehumidifier from the power source before starting this replacement project as a safety precaution.

Bi-Metal Thermostat Control with Clamp

Also known as Dehumidifier anti-icing thermostat with clamp.

$58.12

Bucket Water Level Switch

This part is for your dehumidifier. The bucket water level switch is used to prevent water overflow when the bucket is full. You will not be able to tell if the switch has failed just by looking at it. You will need to perform a continuity test. This will determine if a continual electrical path is present. If you notice that dehumidifier will not run even when the bucket is empty, it might be due to the switch needing to be replaced. To access the part, you will need to remove all the outer housing. The switch is located in a plastic holder found on the inside wall.

$144.15

Fan Motor

This fan motor controls the circulating fan in the dehumidifier.

$4.89

Screw

Sold individually.

Castor

Also known as wheel or roller. This part is sold individually.

PAN-DRAIN

HUMIDISTAT

$27.47

KNOB

All Parts for the DH40J0
1-14 of 59