Models > DH40H0

DH40H0 Whirlpool Dehumidifier - Overview

Get Parts and Repair Help for DH40H0

If you know the dehumidifier repair part you need, you can browse the list of all parts on the DH40H0, or you can search by name or part description. You can also find your part by where it is located on the DH40H0 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DH40H0 [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.04

FLOAT

Order within the next 9 hrs and your part ships today!
$2.70

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Order within the next 9 hrs and your part ships today!
$4.01

Float Clip

Order within the next 9 hrs and your part ships today!
$56.54

Bucket and Float Kit

Order within the next 9 hrs and your part ships today!
$111.20

Fan Motor

This fan motor controls the circulating fan in the dehumidifier.

Order within the next 9 hrs and your part ships today!
$31.61

Humidistat Control

Order within the next 9 hrs and your part ships today!
$4.05

SCREW

Sold individually.

Order within the next 9 hrs and your part ships today!
$51.81

Bucket Water Level Switch

This part is used to prevent water overflow when the bucket gets full.

Order within the next 9 hrs and your part ships today!
$45.00

Bi-Metal Thermostat Control with Clamp

Also known as Dehumidifier anti-icing thermostat with clamp.

Order within the next 9 hrs and your part ships today!

Castor

Also known as wheel or roller. This part is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The origional humidistat quit working

  • Customer: James from Silver Bay MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 8 of 12 people found this instruction helpful
The knob one turns to set the humidity level was removed. The two screws holding the top on were removed. The top was lifted and swung to the side. After noting which of the two wires went where on the humidistat the wires were removed. Small flat screwdrivers were used to pry back the plastic retainers on one side of the original failed humidistat. The new ... read more

Evaporator freeze up

  • Customer: Greg from Suches GA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 10 people found this instruction helpful
Troubleshoot on the schematic/wiring diagram to find the defective thermostat. Order a replacement part. Remove all outer covers to gain access to the thermostat. Only tool needed for this is a #2 phillips screwdriver. Cut the leads on the defective part and remove thermostat and replace thermostat, wire cutters/crimper required, splice the thermostat leads... read more

the humidity control broke

  • Customer: larry from tampa FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 13 people found this instruction helpful
Taking the case apart and replacing the control unit was a piece of cake. And the part arrived the very day after I ordered it. read more