Models > DGHD2433KF1

DGHD2433KF1 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for DGHD2433KF1

If you know the dishwasher repair part you need, you can browse the list of all parts on the DGHD2433KF1, or you can search by name or part description. You can also find your part by where it is located on the DGHD2433KF1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for DGHD2433KF1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$11.18

Upper Spray Arm

This part is located on the top of the tub.

$10.40

Tub Gasket - Gray

The gasket provides a waterproof seal between the tub and the door.

$22.55

Water Inlet Valve - 120V 60Hz

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the d...

$8.68

Bottom Door Gasket

This gasket goes on the bottom of the dishwasher door.

$3.27

Heating Element Brass Nut

This nut is sold individually. It is used to install the heating element.

$41.75

Silverware Basket

This is a basket for washing flatware or silverware in your dishwasher.

$16.18

Splash Shield Kit

This is installed at the bottom corners of the door seal.

$41.35

PUMP ASSEMBLY

$16.73

Lower Rack Wheel with Clip

Sold individually. Order quantity required.

$15.36

HOSE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The spray arm would fall off during the washing cycle.

  • Customer: Roy from Worcester MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 446 of 450 people found this instruction helpful
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having the problem that the a... read more

Leak in the water inlet valve/solinoid

  • Customer: Mickey from Ooltewah TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 111 of 120 people found this instruction helpful
1. Shut off water supply.
2. Removed inlet water hose where it connects to the vavle assembly.
3. Removed the two bracket screws holding the assembly to the frame, and detached the electrical connection from the solinoid.
4. Removed the inlet hose adapter connection from old valve and installed into new valve.
5. Attached electrical con... read more

dishwasher was leaking water

  • Customer: Charles from Milton FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 59 of 71 people found this instruction helpful
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in. read more