Models > DG18F2HW > Parts

DG18F2HW Admiral Dryer - Parts

All parts for the Admiral Dryer DG18F2HW

Below is a list of all parts for the Admiral Dryer DG18F2HW - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the DG18F2HW
1-14 of 96
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Multi Rib Belt - 92-1/4"

This dryer drum belt has four ridges, three grooves and is 1/4" wide.


'M' Series New Style Coil Kit

This gas dryer ignition coil set comes with two ignition coils: one three terminal Boost/Hold coil, and one two terminal secondary coil. Usually only one of them burns out but you should replace them as a set. Both have to be operational for the gas valve to open.


Radiant Flame Sensor

This part senses the flame for heat allowing the gas valve to open.


High Limit Kit

This kit comes with three separate thermal fuses and is usually used with clothes dryers that have a fan mounted on the motor shaft. Included within this kit is the high limit (Limit: 258) the gas high limit (Limit: 240) and the gas and electric high limit thermostat (Limit: 300).



This screw is sold individually.


Rear Drum Support Roller Kit

Included in this rear drum support roller kit are 4 screws, 1 spacers, 2 washers, 2 retaining rings, 2 rear rollers, and 2 cylinder support shafts. *** Note: Per manufacturer this kit has been updated now to have one spacer that is the thickness of 2 spacers. To get these parts separately, please search by model#.


Blower Wheel Clamp

This clamp is used for the blower wheel.



This screw is sold individually.


Front Glide Kit

This kit includes 2 glides (left and right), 2 pads with adhesive backing and 1 support brace.


Drum Felt Seal

Depending upon your model, this seal can be used on either the front or rear drum. The hi-temp adhesive is sold separately.



This screw is sold individually.


Igniter with Wire Harness

This part lights the gas burner to create heat.


Drum Glide and Cushion Kit

Pad has adhesive backing.


Blower Wheel

This blower wheel is manufactured to fit a 1/2 inch motor shaft.

All Parts for the DG18F2HW
1-14 of 96