Models > DENNIS > Instructions

DENNIS General Electric Microwave - Instructions

All Instructions for the DENNIS
1 - 7 of 7
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Floor of microwave cracked
Removed the broken pieces of the microwave floor and placed the new one in, careful that the gasket didn't slip off.
Parts Used:
Ceramic Tray - White
  • Rich from Baltimore, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
9 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
loud hum & the microwave quit working
remove the housing,replaced the magnetron and reassembled.no problems at all
Parts Used:
Magnetron
  • Richard from Yorktown Heights, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
5 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bottom Of Oven Cracked
Removed broken bottom tray no tools needed slid new tray in, rather a tight fit because of the gaskets around the edges. The door now must be more firmly closed. Works fine. . Wife happy. . . . . . .
Parts Used:
Ceramic Tray - White
  • RICHARD from Santa Rosa, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
5 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ceramic base in microwave split
Pulled old base up easily with screwdriver. Slipped new base in very easily. Perfect fit.
Parts Used:
Ceramic Tray - White
  • Michael from Fort Myers, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
3 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
oven made a loud buzzing & would not heat
completly removed outer cabinet,discharged capicator,removed some internal parts so I could get at the magnetron,
.removed replaced magnetron,reinstalled inner parts& cabinet .tested microwave viola
everything worked again.
Thanks, PartsSelect
Ernie
Parts Used:
Magnetron
  • Ernest from Riverview, MI
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver, Pliers, Screw drivers
3 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rack in freezer keep falling down.
The spacer just snapped onto the rack giving it a little more width to hold the shelf on the guides. Not the best fit but hopefully will do the trick long term. I thought it would have been a bigger part.
Parts Used:
SPACER-RACK
  • Beverly from PARSIPPANY, NJ
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
3 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Stopped heating and had a banging noise
I took instant pictures at each step to make sure I put the wires back correctly. Removed the front panel. Discharged the capacitor with a voltage meter. Removed parts in front of the magnetron. Removed and replaced the magnetron. Reassembled. Works find now. Small hands, a flashlight and a magnet (for dropped screws) would help. I did not need the pictures.
Parts Used:
Magnetron
  • Alan from Bonita, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DENNIS
1 - 7 of 7
Back to Top