Models > DE906

DE906 Maytag Dryer - Overview

Get Parts and Repair Help for DE906

If you know the dryer repair part you need, you can browse the list of all parts on the DE906, or you can search by name or part description. You can also find your part by where it is located on the DE906 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DE906 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$2.70

Drum Roller Shaft Washer

This part is sold individually.

$2.70

Screw

Sold individually.

$3.96

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Screw

This screw is sold individually.

$7.08

Rubber Foot Pad

This foot pad is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers. Sold individually.

$198.64

Lower Dishrack Kit

This kit comes with the wheels, bumpers, fold down tine and flexrow retainer.

$2.70

SCREW

Sold Individually.

$23.22

Cycling Thermostat

Cycling thermostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 140 degrees Fahrenh...

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer wouldn't heat

  • Customer: Edith from Grove City OH
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 28 of 35 people found this instruction helpful
Since the heating coil is right behind the front door I had to remove all panels starting with the back one to get to it. The back has a lot of tech screws that I removed with the nut driver. The side panels were removed with a phillips screwdriver. The top is held in place with the other panels. The base was shifted away from the front and I released th... read more

rollers and clips on botton dishrack were broken

  • Customer: Diane from Waltham MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 17 of 25 people found this instruction helpful
I pulled off the old clips and easily replaced them with the new clips and popped on the wheels.
I replaced 8 clips and 8 wheels in less than 15mins read more

Dryer not heating

  • Customer: William from Exmore VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 10 of 11 people found this instruction helpful
First let me say that this dryer is at least 30 years old. The only repairs it has needed up to this point were a set of belts and lint screen holder.

I researched and found a list of items to check for dryer not heating. Only 3 items were listed as possible causes, the Heating Element, Cycling Thermostat, and Heating Element Terminal & Insulator.... read more