Models > DE90 Maytag

DE90 Maytag Dryer - Overview

Get Parts and Repair Help for DE90

If you know the dryer repair part you need, you can browse the list of all parts on the DE90, or you can search by name or part description. You can also find your part by where it is located on the DE90 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DE90 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Drum Roller Shaft Washer

Sold individually.



This screw is sold individually.



Sold individually.


Cycling Thermostat - Limit: 135/155

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.


Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.


Rubber Foot Pad

This foot pad is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers. Sold individually.



Sold Individually.


Lower Dishrack Kit

This kit comes with the wheels, bumpers, fold down tine and flexrow retainer.


Cycling Thermostat

Cycling thermostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 140 degrees Fahrenh...


Heater Wire - 240V

This heater wire is 240V and is 79" long.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer wouldn't heat

  • Customer: Edith from Grove City OH
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 41 of 48 people found this instruction helpful
Since the heating coil is right behind the front door I had to remove all panels starting with the back one to get to it. The back has a lot of tech screws that I removed with the nut driver. The side panels were removed with a phillips screwdriver. The top is held in place with the other panels. The base was shifted away from the front and I released th... read more

Lower Dishwasher rack replacement

  • Customer: Claire from Saratoga springs NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 28 of 43 people found this instruction helpful
I ordered the part and was hoping to just take out one rack and put in the other, there were NO instructions or even a diagram of the rack. There was a fold down rack that was not attached and a few parts that I have no idea what they are. This was very discouraging. The main thing is that the rack is quite a bit lighter than the original one so I doubt i... read more

Temperature setting not working

  • Customer: Robert from Buffalo NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 14 of 17 people found this instruction helpful
Took off back cover, thermostat was easily identified because of photos I've seen on website. Took 2 connectors off, removed 2 screws and removed old thermostat. That was pretty much it!

NOTE: Replacement thermostat 694674 has an adjustable temperature range setting that MUST be manually set prior to installing! You need to use the enclosed chart ... read more