Models > DE600EDW1

DE600EDW1 Frigidaire Dryer - Overview

Get Parts and Repair Help for DE600EDW1

If you know the dryer repair part you need, you can browse the list of all parts on the DE600EDW1, or you can search by name or part description. You can also find your part by where it is located on the DE600EDW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DE600EDW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.92

Rear Drum Bearing Kit

This kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant and installation screws.

$2.77

Drum Support Bearing

$3.22

Door Latch Kit

This door latch kit comes with the strike and the catch.

$23.71

Door Catch

$8.29

Bearing Bracket

$3.51

Main Terminal Block Kit

$11.14

Flat Style Belt

This is a flat style ridgeless dryer belt.

$9.82

Idler Pulley Assembly

Use this idler pulley assembly with gas or electric clothes dryer that has a flat dryer belt. ***Please NOTE: This part has been redesigned by the manufacturer and may not fit your appliance.

$29.57

Seal

Adhesive is sold separately.

$25.23

High Temperature Adhesive

Used for installing felt and rubber seals on dryers.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loud Squeaking

  • Customer: Frank from Boyertown PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 245 of 253 people found this instruction helpful
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Acc... read more

Catch broke, door wouldn't stay closed.

  • Customer: Dianne from Kansas City MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 34 of 35 people found this instruction helpful
Used a screwdriver to pop out broken piece. Used pliers to snap in new one. read more

Dryer drum would squeak and squeal until warmed up, but progressively got worse as the days drug on.

  • Customer: Chad from Glyndon MN
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers, Wrench set
  • 17 of 18 people found this instruction helpful
First pry up on the front edge of the top panel of the dryer which is held in place by snap in clips. Pivot the top open and support against wall or other taking care not to pull on wiring harness. Next remove the 2 screws that hold the front panel in place. These are located on the inside of the front panel. The front then snaps loose also. Remove the plast... read more