Models > DE27S6WPMC

DE27S6WPMC Frigidaire Dryer - Overview

Get Parts and Repair Help for DE27S6WPMC

If you know the dryer repair part you need, you can browse the list of all parts on the DE27S6WPMC, or you can search by name or part description. You can also find your part by where it is located on the DE27S6WPMC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DE27S6WPMC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.77

Drum Support Bearing

$23.71

Door Catch

$8.29

Bearing Bracket

$3.51

Main Terminal Block Kit

$6.93

Grounding Ball

$11.14

Flat Style Belt

This is a flat style ridgeless dryer belt.

$9.82

Idler Pulley Assembly

Use this idler pulley assembly with gas or electric clothes dryer that has a flat dryer belt. ***Please NOTE: This part has been redesigned by the manufacturer and may not fit you...

$29.57

Seal

Adhesive is sold separately.

$4.16

Touch Up Paint

This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.

$25.23

High Temperature Adhesive

Used for installing felt and rubber seals on dryers.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Cord was not tightened enough by delivery crew.

  • Customer: Timothy from Spring Valley AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 26 of 48 people found this instruction helpful
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screw... read more

Broken Dryer Belt

  • Customer: Tod from West Springfield MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 14 of 17 people found this instruction helpful
1st I pried the dryer top open then disconnected the two wires for the auto shut-off. Removed four nuts with driver that opens front and releases dryer barrel. Lifted front up a bit to remove from two lower tabs at bottom of unit and put aside.

I then slid the belt over the barrel noting the side up directions on the belt. On the lower left on th... read more

My husband ruined the old latch by trying to shut the door too hard, and the old latch fell down into the inside of the dryer.

  • Customer: Michelle from Dallas TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 10 of 13 people found this instruction helpful
I took the new latch out of the package and snapped it into place. It took about 15 seconds, and that included the walk to the laundry room! read more