Models > DE150EDW1

DE150EDW1 Frigidaire Dryer - Overview

Get Parts and Repair Help for DE150EDW1

If you know the dryer repair part you need, you can browse the list of all parts on the DE150EDW1, or you can search by name or part description. You can also find your part by where it is located on the DE150EDW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DE150EDW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.92

Rear Drum Bearing Kit

This kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant and installation screws.

$2.77

Drum Support Bearing

$3.22

Door Latch Kit

This door latch kit comes with the strike and the catch.

$23.71

Door Catch

$3.51

Main Terminal Block Kit

$8.29

Bearing Bracket

$9.82

Idler Pulley Assembly

Use this idler pulley assembly with gas or electric clothes dryer that has a flat dryer belt. ***Please NOTE: This part has been redesigned by the manufacturer and may not fit you...

$9.06

Flat Style Belt

This is a flat style ridgeless dryer belt.

$25.23

High Temperature Adhesive

Used for installing felt and rubber seals on dryers.

$29.57

Seal

Adhesive is sold separately.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loud Squeaking

  • Customer: Frank from Boyertown PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 249 of 257 people found this instruction helpful
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Acc... read more

bearing and heating element broke

  • Customer: Kevin A Frech from Sidney IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 57 of 82 people found this instruction helpful
Had to first remove the top of the dryer this was done by removing the clamps on the back. Next I removed the front of the dryer by removing the two nuts the frong in the inside, these are somewhat hard to reach. Next the drum was removed. then the heating element shield. Replaced, the heating element then secured it into place. replaced the drum bearin... read more

Catch broke, door wouldn't stay closed.

  • Customer: Dianne from Kansas City MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 35 of 36 people found this instruction helpful
Used a screwdriver to pop out broken piece. Used pliers to snap in new one. read more