Models > DCXR463GA2WW

DCXR463GA2WW General Electric Dryer - Overview

Get Parts and Repair Help for DCXR463GA2WW

If you know the dryer repair part you need, you can browse the list of all parts on the DCXR463GA2WW, or you can search by name or part description. You can also find your part by where it is located on the DCXR463GA2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DCXR463GA2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$6.14

Drum Bearing Slide - White

Sold individually. There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time.

$18.13

Front Drum Bearing

Note: The drum slides should also be replaced when your replacing the drum bearing. Slides are NOT included. This part helps your dryer operate as quietly as possible.

$3.62

D-Shaped Knob Insert Clip

Sold individually.

$5.55

Duct Felt Seal

$19.98

Drive Belt

This drive belt is 89.5" long.

$7.32

Selector Knob with Clip

This white knob accepts a D-shaped shaft. Sold individually.

$46.29

Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running...

$26.67

Rotary Start Switch

This part is used to start the dryer once you have selected a setting on the timer.

$8.98

HANDLE WHITE

$14.88

Idler Pulley Wheel

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced broken START knob on dryer.

  • Customer: SAM from ROCK HILL NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 470 of 474 people found this instruction helpful
Slid off the old START knob, then pushed on the new START knob.

I created and printed a label on my computer for use with the time selector dial, which must be set at or beyond 10 minutes, before turning the START knob.

I made a label that says "Minimum" with a red arrow that points past the 10 minute setting on the time selector dial.<... read more

The inside of the Selector Knob was stripped

  • Customer: Frank from Irvine CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 369 of 372 people found this instruction helpful
Removed the damaged knob and replaced it with the new knob. Very ease read more

original duct was broken

  • Customer: Chad from Gilbert SC
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 87 of 93 people found this instruction helpful
Dear PartSelect.com,

My repair went off without a hitch.

2 screws removed to remove top.
4 screws removed from inside to remove front panel w/ door.
4 screws removed from top of control panel, loosed and popped top right off.
Flathead screwdriver to pop off old plastic panel.
Removed old wire chase (plastic, approx 3... read more