Models > DCD330GY0AC

DCD330GY0AC General Electric Dryer - Overview

Get Parts and Repair Help for DCD330GY0AC

If you know the dryer repair part you need, you can browse the list of all parts on the DCD330GY0AC, or you can search by name or part description. You can also find your part by where it is located on the DCD330GY0AC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DCD330GY0AC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$14.09

Rear Bearing

Bearing Only. This part helps your appliance run as quietly as possible.

$46.77

Drum Belt

Used to turn the drum.

$88.00

Rear Bearing Kit

This kit comes with the rear bearing, shaft support, lubricant and other items required for the installation.

$97.18

Top Drum Glide Kit

This top drum glide kit comes with the adhesive.

$15.45

Igniter

This igniter is used for gas dryers. This part ignites the gas within the dryer.

$69.64

Rear Bearing Shaft Support

$66.86

Lower Felt Seal

$4.49

SCREW

$105.80

Gas Valve Coil Kit

This dryer solenoid kit comes with both the 2 and 3 wire coil valves.

$13.04

Grounding Ball

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loud noise & clothes hanging in drum.

  • Customer: Raul from Fountain CO
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 52 of 55 people found this instruction helpful
1. Remove power cord from wall outlet. Unlatched the top lid of the dryer by pushing a flat screwdriver under the R & L sides where a metal clip on each side holds the top down.
2. Removed the yellow clip screwed onto the top frame.
3. Removed the front frame of the dryer by unscrewing the two screws holding the front frame on – one on either sid... read more

Loud rhythmic squeaking

  • Customer: Mark from San Diego CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 26 of 33 people found this instruction helpful
About a year ago I had to replace the front sliders. I had thought at the time that I should replace the belt and check the rear bearing, but I was in a hurry, and the wash was backing up, so I didn't do it. Oops. Within 6 months dryer started squeaking. Did I get around to pulling it out, and greasing rear bearing. Nope. Dbl oops.

Luckily on... read more

loud squeak/burnt edges of clothes

  • Customer: Philip from Irmo SC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 11 of 11 people found this instruction helpful
I used the puddy knife at the top of the front panel seam. I pushed in the knife till I heard the top panel release. I then did the other side of the front panel till I heard the same sound.I now could raise the top of the dryer. Inside the front panel(on the left and the right) are two philips head screws that I loosened and took off, releasing the front p... read more