Models > DCCH43GA3WW

DCCH43GA3WW General Electric Dryer - Overview

Get Parts and Repair Help for DCCH43GA3WW

If you know the dryer repair part you need, you can browse the list of all parts on the DCCH43GA3WW, or you can search by name or part description. You can also find your part by where it is located on the DCCH43GA3WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$13.25

Rear Bearing

Bearing Only. This part helps your appliance run as quietly as possible.

$83.07

Rear Bearing Kit

This kit comes with the rear bearing, shaft support, lubricant and other items required for the installation.

$43.57

Drum Belt

Used to turn the drum.

$27.34

Drum Glide

Sold individually. There are some dryers that require 2 per dryer. They attach to the outer-most sides of the bearing.

$55.96

Upper Felt Seal with Adhesive

$15.00

Igniter

This igniter is used for gas dryers. This part ignites the gas within the dryer.

$40.36

Handle

Screws are not included. Handle only.

$24.77

Bearing Bracket

This bracket is used on the drum bearing.

$60.66

Lower Felt Seal with Adhesive

$5.55

SCREW-LOCK 10-16X 50

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loud rhythmic squeaking

  • Customer: Mark from San Diego CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 22 of 27 people found this instruction helpful
About a year ago I had to replace the front sliders. I had thought at the time that I should replace the belt and check the rear bearing, but I was in a hurry, and the wash was backing up, so I didn't do it. Oops. Within 6 months dryer started squeaking. Did I get around to pulling it out, and greasing rear bearing. Nope. Dbl oops.

Luckily on... read more

Loud screeching noises from the rear of the dryer whenever in was running.

  • Customer: Kenneth from Boise ID
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 5 of 6 people found this instruction helpful
We unlatched the top of the dryer by pushing a screwdriver under the two areas where there were metal clips holding it down. We then removed the yellow clip screwed onto the top frame. We removed the front frame of the dryer by unscrewing the two screws holding the front frame on--one on either side. We didn't undo the wiring to the controls, we just kind ... read more

Dryer was squeeking for a while, and then eventually just quit working.

  • Customer: Jesse from Battle Ground WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 4 of 4 people found this instruction helpful
Took the top and the front panel off (took me a while to figure this out without breaking stuff). Took off belt, pulled out drum, replaced bearing, and then I also had to replace the ball (attached to rear of drum, which slides inside the bearing). read more