Models > DCCH43EA0WW

DCCH43EA0WW General Electric Dryer - Overview

Get Parts and Repair Help for DCCH43EA0WW

If you know the dryer repair part you need, you can browse the list of all parts on the DCCH43EA0WW, or you can search by name or part description. You can also find your part by where it is located on the DCCH43EA0WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$13.25

Rear Bearing

Bearing Only. This part helps your appliance run as quietly as possible.

$83.07

Rear Bearing Kit

This kit comes with the rear bearing, shaft support, lubricant and other items required for the installation.

$43.57

Drum Belt

Used to turn the drum.

$87.98

Top Drum Glide Kit

This top drum glide kit comes with the adhesive.

$65.34

Rear Bearing Shaft Support

$40.36

Handle

Screws are not included. Handle only.

$63.02

Lower Felt Seal

$37.80

High Limit Safety Thermostat

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. The element will kick back in when the temperature drops to 190 degrees Fahrenheit - the differential of 70 degrees.

$15.59

LEVELING FOOT

$12.62

Grounding Ball

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loud noise & clothes hanging in drum.

  • Customer: Raul from Fountain CO
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 47 of 50 people found this instruction helpful
1. Remove power cord from wall outlet. Unlatched the top lid of the dryer by pushing a flat screwdriver under the R & L sides where a metal clip on each side holds the top down.
2. Removed the yellow clip screwed onto the top frame.
3. Removed the front frame of the dryer by unscrewing the two screws holding the front frame on – one on either sid... read more

No Heat!

  • Customer: Kristian from Jackson WY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 41 of 58 people found this instruction helpful
Unplug power. Take the top off. Take front off, unplug the two wire connections. Undo belt from back access. Pull up on drum and remove. Unscrew 4 screws that hold on the element housing, remove. Reverse steps to put back together. read more

Loud rhythmic squeaking

  • Customer: Mark from San Diego CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 22 of 27 people found this instruction helpful
About a year ago I had to replace the front sliders. I had thought at the time that I should replace the belt and check the rear bearing, but I was in a hurry, and the wash was backing up, so I didn't do it. Oops. Within 6 months dryer started squeaking. Did I get around to pulling it out, and greasing rear bearing. Nope. Dbl oops.

Luckily on... read more