DC24D6-A Maytag Dishwasher - Instructions

replaced the faucet adapter I did not save when I change out the kitchen sink faucet set

power off, take off kickplate, unplug 2 wires and unscrew broken nuts, put new nuts on, plug wires back in,(run dishwasher one cycle to make sure no leaks) put kickplate back on, power on.

Ordered a new Faucet Adapter! Simple

Found the adapter on Parts select through a google search. Unscrewed the existing faucet aerator and srewed in the adapter. The plastic shrink wrap holds the washer and screen in place, so don't open it until you're ready to install. Finger snug does it, only use the pliers to remover the old aerator from the faucet. Normally, I don't use pliers, but both of these parts were round and had vertical serrations to engare the plier teeth.

Ditto the other comments. Easy, great savings. Perfect. Thank you!

first I shut off power at breaker then took off bottom panel,removed old nuts had a problem with the 1 in the back had to remove a few wires to be able to reach in.Then i open door removed dishwasher rack and heater element notice that the hole was rusted out a little so I cleaned area up and used permatex silicone all the area installed the new grommets replaced the heating element put it all back together will test for leaks after silicone cures

Spotted the source of the leak at the first heating element under the dishwasher. Removed the brass mounting nut and it was cracked. Replaced with new part from PartSelect.com and the leak was fixed. Apparently the heating element gets so hot it tends to crack the mounting nuts, which results in a leak. Delivery time for part said 3-5 days - mine arrived one day after ordered!