Models > DBXR463EB2WW

DBXR463EB2WW General Electric Dryer - Overview

Get Parts and Repair Help for DBXR463EB2WW

If you know the dryer repair part you need, you can browse the list of all parts on the DBXR463EB2WW, or you can search by name or part description. You can also find your part by where it is located on the DBXR463EB2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DBXR463EB2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.91

Drum Bearing Slide - White

Sold individually. There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time.

Order within the next 10 hrs and your part ships today!
$5.55

Duct Felt Seal

Order within the next 10 hrs and your part ships today!
$4.05

D-Shaped Knob Insert Clip

Sold individually.

Order within the next 10 hrs and your part ships today!
$13.77

Timer Knob

This dryer knob accepts a D-shaped shaft.

Order within the next 10 hrs and your part ships today!
$19.98

Drive Belt

This drive belt is 89.5" long.

Order within the next 10 hrs and your part ships today!
$7.91

Rotary Start Switch

This part is used to start the dryer once you have selected a setting on the timer. The terminal locations on the new switch may be different, match up terminal numbers from old switch to new.

Order within the next 10 hrs and your part ships today!
$3.79

Light Bulb - 120V 10W

Order within the next 10 hrs and your part ships today!
$46.29

Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running as smoothly as possible with as little noise as possible.

Order within the next 10 hrs and your part ships today!
$35.25

Lint Filter and Frame

Order within the next 10 hrs and your part ships today!
$8.91

Knob and Clip

This knob accepts a D-shaped shaft.

Order within the next 10 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer was squeeling when running.

  • Customer: Daniel from Chicago IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 446 of 450 people found this instruction helpful
I removed the two screws at the front above the drum opening (with the dryer door open). The top panel then lifts off. I removed the screw at each side that holds the front panel to the side panels, tilted the front panel forward, which disengages the front of the drum from the front drum glide bearing. I then lifted the front panel slightly, unhooking th... read more

Timer knob cracked and would not turn on the dryer

  • Customer: Kathleen from Greenwood IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 144 of 209 people found this instruction helpful
Very easy. I just snapped the new timer knob on and I was ready to go. read more

original duct was broken

  • Customer: Chad from Gilbert SC
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 90 of 96 people found this instruction helpful
Dear PartSelect.com,

My repair went off without a hitch.

2 screws removed to remove top.
4 screws removed from inside to remove front panel w/ door.
4 screws removed from top of control panel, loosed and popped top right off.
Flathead screwdriver to pop off old plastic panel.
Removed old wire chase (plastic, approx 3... read more