Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DBLR333EE1WW > Parts

DBLR333EE1WW General Electric Dryer - Parts

All parts for the General Electric Dryer DBLR333EE1WW

Below is a list of all parts for the General Electric Dryer DBLR333EE1WW - Electric . To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the DBLR333EE1WW
1-14 of 92
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.85

Drum Bearing Slide - White

This is a drum bearing slide, also known as bearing drum slide, glide, or pad, that is fitted to a dryer. The slide functions by supporting the front drum as the drum rotates. This...

$4.31

Drum Bearing Slide - Green

The drum slides give support to the front of the dryer drum. As they start to break down it may cause your dryer to make noise or not dry clothes in an appropriate amount of time. This item is sold individually. You will need to purchase two as there are two located in your dryer. They attach to the outer-most sides of the bearing. The manufacturer recommends replacing both slides at the same time. Use this as an opportunity to clean out the lint and dust in the dryer to keep your machine running smoothly. This is a genuine replacement part that comes directly from the manufacturer.

$44.72

Front Drum Bearing

This front drum bearing helps your dryer operate as quietly as possible. It is about 10 inches in height and 22 inches in width. It is made entirely out of plastic and is white in ...

$16.96

Timer Knob

This is a timer knob and it is used in conjunction with your dryer. This knob is white with a silver trim, it measures to have a roughly three-inch outer diameter, and it accepts a D-shaped shaft. The most likely reason you will need to replace this part is if your timer will not advance, or if your dryer will not start. No tools are required for you to make this repair. To install this part, grab your old knob with a firm grip and pull. Make sure that during this first step the inside of the part has come off as well. Next you will align your new part to the D-shaped shaft and snap it into place.

$6.17

Duct Felt Seal

This is a duct felt seal for a dryer. The duct felt seal allows the front-load dryer drum to glide smoothly on the front panel. Your dryer will not function properly if the drum fe...

$23.59

Drive Belt

This is a dryer drum drive belt. It is 89.5 inches long with four ribs on the inside for a better grip. The drive belt on your dryer attaches to the motor pulley and then wraps around the drum and a tensioner pulley, and spins the drum as the motor rotates. Your dryer drum cannot spin without this belt. Belts can stretch or become brittle over time which may cause it to malfunction. This is an original manufacturer replacement part. Be sure to use work gloved to protect your hands from sharp internal parts during this repair.

$4.56

D-Shaped Knob Insert Clip

This clip ensures that the knob is securely fastened to the control shaft, allowing you to properly select the correct time and setting for your dryer. If your dryer will not start...

$51.71

Rear Drum Bearing Kit

This rear drum bearing kit includes a shaft, ground strap, bearing, seven screws, and installation instructions. The bearing plate comes with a slot in it for the ground strap. This part helps keep your dryer running as smoothly as possible with as little noise as possible by supporting the back of the dryer drum and reducing friction as the drum rotates. Over time, your drum bearing will wear out, cause your dryer to be noisy, and you will have to replace it. There may be some sharp internal parts, so be sure to wear work gloves during repair.

$10.88

Door Handle - White

This part is on the outer door of the dryer.

$38.03

Cycling Thermostat - 4 Wire

This thermostat helps to regulate the dryer's internal temperature. L210-30F

$69.06

Lint Trap Duct Assembly

This part includes the duct felt seal (PS9861764) and gasket (PS2577674). NOTE: Per manufacturer this part no longer comes with the sensor bars.

$17.93

Idler Pulley Wheel

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$11.19

Knob and Clip

This knob accepts a D-shaped shaft.

$3.71

LATCH DOOR

This door latch is designed for your dryer, and is mounted to the dryer frame. The door latch holds the door of your dryer closed while the machine is operating. If your dryer door is not catching on the door strike, and will not stay closed, you may need to replace the door latch. This part is square in shape, and is approximately 3/4-inch in length, by 3/4-inch in width. The part is made of white plastic with a metal tab. To access the door latch, you will need to remove the top and side panels on your dryer. To complete this repair, simply pop the damaged door latch out of position, and snap the new one into place.

All Parts for the DBLR333EE1WW
1-14 of 92