Models > DBLR333EE0WW

DBLR333EE0WW General Electric Dryer - Overview

Get Parts and Repair Help for DBLR333EE0WW

If you know the dryer repair part you need, you can browse the list of all parts on the DBLR333EE0WW, or you can search by name or part description. You can also find your part by where it is located on the DBLR333EE0WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DBLR333EE0WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.86

Drum Bearing Slide

There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time. Sold individually.

$6.14

Drum Bearing Slide - White

Sold individually. There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time.

$18.13

Front Drum Bearing

Note: The drum slides should also be replaced when your replacing the drum bearing. Slides are NOT included. This part helps your dryer operate as quietly as possible.

$3.62

D-Shaped Knob Insert Clip

Sold individually.

$13.77

Timer Knob

This dryer knob accepts a D-shaped shaft.

$5.55

Duct Felt Seal

$19.98

Drive Belt

This drive belt is 89.5" long.

$46.29

Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running as smoothly as possible with as little noise as possible.

$29.49

Lint Filter and Frame

$8.91

Knob and Clip

This knob accepts a D-shaped shaft.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Due to over loading of the dryer the drum ruined the slides and was making a bad noise due to plastic rubbing plastic

  • Customer: Matthew from Plainfield IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 493 of 497 people found this instruction helpful
It was pretty easy. After already taking apart the dryer to install a new belt I knew exactly my plan of action. I removed the two screws that hold the top panel of the dryer to the front panel. I then removed the top panel and removed the screws that hold the front to each side panel. I than pulled the front away from the cabinet and drum. I put the ne... read more

Intermittant squeaking noise

  • Customer: Mark from Addison IL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 419 of 492 people found this instruction helpful
Basically, I followed the same steps a prior person posted.
1.Removed the two screws inside the door, on the top part of the opening.
2.Lifted up and removed the top.
3.Removed two screws holding the front panel in place.
4.Held up the drum while removing the front panel. I carefully turned the panel so I could get at the drum bearing wit... read more

Timer knob cracked and would not turn on the dryer

  • Customer: Kathleen from Greenwood IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 144 of 209 people found this instruction helpful
Very easy. I just snapped the new timer knob on and I was ready to go. read more