Models > DA3100

DA3100 Amana Washer - Overview

Get Parts and Repair Help for DA3100

If you know the washer repair part you need, you can browse the list of all parts on the DA3100, or you can search by name or part description. You can also find your part by where it is located on the DA3100 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for DA3100 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.66

Inlet Hose Gasket

$3.96

Single Washer Inlet Strainer

Found at the end of the inlet hoses.

$2.70

Screw - 12-14 x 1/2 Type B

$4.46

Rubber Foot Pad

This pad is used for the levelling legs of many washing machines.

$4.60

Nut

$4.60

Screw - 8-18 x 1/2

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water Inlet Valve Damaged

  • Customer: Ronald from Arcadia CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Wrench(Adjustable)
  • 5 of 5 people found this instruction helpful
The Speed Queen people were nice enough to provide a swing out door on the back of the machine to access the mixing valve. I had to pry it open because they did not supply enough slack in the hose that attaches to the mixing valve. The hose clamp securing the outlet hose to the valve was difficult to remove as the screw was positioned by someone that assem... read more

Bad tube seals and bearings

  • Customer: DAVID from SANDY HOOK CT
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Socket set, Wrench set
  • 1 of 1 people found this instruction helpful
Disassembled washer as per directions with seal kit. Removed inner tub. Cut both tub shaft bearing in half; punched out from outter tub. Installed new bearings using .5 inch threaded rod, washer and bolts. Installed new seal on inner tub shaft. Installed inner tube. Re-assembled washer. read more

Water leaked into the drum while turned off cycle.

  • Customer: Brian from Evansville IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
As another person commented, there is a small 'door' on the rear where the water inlet is located. Don't know if this was meant for easy access to change this part or not but I didn't use it. I found it much easier to just remove the front panel (2 lower corner screws), loosen the top (2 corner screws) and tilt it up and out of the way. From there it was ... read more