Models > D30B0

D30B0 Whirlpool Dehumidifier - Overview

Get Parts and Repair Help for D30B0

If you know the dehumidifier repair part you need, you can browse the list of all parts on the D30B0, or you can search by name or part description. You can also find your part by where it is located on the D30B0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dehumidifier. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the D30B0 [Viewing 3 of 3]

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$2.70

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

$2.72

Water Inlet Hose Washer

Sold Individually. Order quantity needed.

$46.34

Humidistat Kit

$46.45

Condensation Drip Pan

$3.83

TIE-WIRE

CORD-POWER

$4.60

SEAL-STRIP

Switch

Full bucket switch.

$56.57

MOUNT-KIT

Common Symptoms of the D30B0 [Viewing 1 of 21]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The humidifier would run continuously regardless of the humidity setting.

  • Customer: Stephen from Richfield NC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 0 of 0 people found this instruction helpful
I removed the old humidistat and replaced it with the new one which was an exact fit. read more

Dehumidifer collection pan (bucket) overflowing with water

  • Customer: Carl from Tuscaloosa AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
The unit should cutoff when the pan gets full enough for it to depress the pan full switch on the back of the unit. Used an ohm-meter to check and see that this switch was bad. Replaced with this part and now it cuts off again when the pan is full. Not hard at all. Take the cover off the unit (screws) then take the switch out (nut) and replace. read more