Models > CWE6230ACE

CWE6230ACE Maytag Oven - Overview

Get Parts and Repair Help for CWE6230ACE

If you know the oven repair part you need, you can browse the list of all parts on the CWE6230ACE, or you can search by name or part description. You can also find your part by where it is located on the CWE6230ACE by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for CWE6230ACE parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

$18.07

2 Piece Broiler Pan

$38.48

Oven Rack

Sold individually.

$56.04

Oven Rack

Sold individually.

$2.70

Screw

This screw is sold individually.

$9.95

Clock Knob

Sold individually. This knob will accept a D-shaped shaft.

$4.46

Light Bulb Socket

This light bulb socket is located inside the oven cavity.

Common Symptoms of the CWE6230ACE [Viewing 1 of 39]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Clock and timer unit not working after lighting storm

  • Customer: David from Plainfield IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 7 of 10 people found this instruction helpful
Removed 4 screws under the top unit that holds the stove control knobs. Open oven door for better view. Tilt whole unit (width of stove) up and out of top flange. Remove knobs for timer and the two control knobs (that operate the range burners) nearest the clock. Take out the screws by these knobs, 2 per knob and then you can get the frame that holds clo... read more

Oven door latch was bent and did not release or lock

  • Customer: Roy from Morgantown WV
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 6 of 9 people found this instruction helpful
Had to disassemble the top of the stove and the control panel on the front. I took digital pictures as I disassembled so I could refer to them when putting the stove back together, especially when disconnecting wiring. It took about 3 hours, but most of that time was spent thoroughly cleaning 16 years of baked on grease from places that are normally unacce... read more

The oven rotary switch went 'POFF' when my wife turned the oven off.

  • Customer: Fred from Fishers IN
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 5 of 7 people found this instruction helpful
First I verified that the breaker was OFF!

We have a build-in Jenn-Air oven. After finding the four screws that held the oven into the enclosure, sliding the oven out was pretty easy since my wife helped me. We used a nut drive to remove the 18+ screws holding the top on the oven.

Using the Internet we entered the switch part number. ... read more