Models > CWE502

CWE502 Maytag Oven - Overview

Parts and Repair Help for models starting with CWE502

If you know the oven repair part you need, you can browse the list of all parts for models starting with CWE502, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for CWE502 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with CWE502

$2.52

Light Bulb - 40W

Sold individually.

$53.76

Bake Element - 240V

This spade-style bake element has push-on wire terminals and is found on the bottom of the oven.

$18.07

2 Piece Broiler Pan

$17.43

Thermostat Knob

This knob accepts a D-shaped shaft.

$17.23

ANCHOR-TIP

$4.60

Screw

This screw is sold individually.

$17.30

Selector Knob with Clip

This knob accepts a D-shaped shaft.

$25.41

Door Seal

This oven door seal is made of rubber and has a metal hook on either end to hold it in place and it sits on top of the glass window pane. Sold individually.

$33.50

Oven Rack

$32.80

Push Button Light Switch - White

As per the manufacture the black switch is no longer available and only available in white.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

bottom heating element in oven disintegrated

  • Customer: DENISE from GERMANTOWN TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 20 of 22 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I threw away the old pieces.

Then I connected the two wires on the new element. I pushed the wires back in the insulation in the wall of the cabinet. Then I inserted the two screws and tightened them in.read more

Oven heating element blew out

  • Customer: Shirley from Dallas TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 9 of 10 people found this instruction helpful
Removed 2 screws, pulled element out. My husband used an ohmmeter to see if the electricity needed to be turned off. It showed no voltage. He could not remove electrical connectors by hand, so he used insulated pliers. When he touched the connectors, a shower of sparks covered the inside of the oven and tripped the breaker switch. Then we noticed the pl... read more

LIGHT SWITCH WAS BROKEN

  • Customer: REY from GAINESVILLE TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 9 of 12 people found this instruction helpful
I REMOVED SCREWS THAT HOLD COVER AND PUT COVER ASIDE. I REMOVED THE BUTTONS AND REMOVED GLASS COVER. I PULLED PANEL OUT FAR ENOUGH T GET TSWITCH WIRES AND INSTALLED SWITCH. BE VERY CAREFUL NOT TO LET WIRES TOUCH METAL. read more