Models > CW2303G

CW2303G (P1122908W G) Amana Washer - Overview

Get Parts and Repair Help for CW2303G

If you know the washer repair part you need, you can browse the list of all parts on the CW2303G, or you can search by name or part description. You can also find your part by where it is located on the CW2303G by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for CW2303G parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Retaining Ring

Sold individually.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Screw

This screw is sold individually.

$14.06

V-Style Drive Belt

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.70

Spring Retaining Clip

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

$2.70

Inlet Hose Gasket

$26.45

Main Tub Bearing Assembly

$2.70

SCREW

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

THE SEAL ON THE BOTTOM OF THE TUB WAS LEAKING

  • Customer: HOWARD from CORTLAND OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench(Adjustable)
  • 29 of 34 people found this instruction helpful
REMOVED THE FRONT OF THE WASHER, THEN LIFTED THE TOP UP AND HELD IT UP WITH A PROP. PULLED THE AGITATOR STRAIGHT UP AND STARTED THE DISASEMBLY. USING THE PHOTOS IN THE HUB AND SEAL KIT WAS A BIG HELP. THE LARGE NUT ON THE OUTPUT SHAFT HAD TO BE CUT OFF WITH MY DREMEL TOOL AND THE HUB REMOVED WITH A WHEELER PULLER. ASSEMBLY WAS PRETTY MUCH STRAIGHT FORWARD. P... read more

Frayed V-belt

  • Customer: John from Milton PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 27 of 30 people found this instruction helpful
VERY EASY!!!
SAFETY FIRST-Always unplug the appliance.
Use 8mm socket to remove front panel screws. Loosened up two hose clamps connected to the pump and removed both lines (Hoses contain water, use a towel) which is located underneath the motor. Disconnect motor electrical connector on the left side of the motor. With socket, remove 4 mounting bra... read more

tub leaking water

  • Customer: Raymond from East Sandwich MA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Socket set, Wrench set
  • 16 of 19 people found this instruction helpful
Took off the agitator, removed inner tub, exposing the hub drive. Found fusion between hub drive and agitator shaft. Rather than using a wheel puller as instructions recommended I got my masonry hammer and removed the drive hub in pieces. Removed debris from the tub. Installed sealant around lower seal as instructed. Re-assembled inner tub, agitator with... read more