Quick Question!

Have you ever purchased from PartSelect.com before?

Models > CW2079CWN

CW2079CWN (WD-10465BD) LG Washer - Overview

Get Parts and Repair Help for CW2079CWN

If you know the washer repair part you need, you can browse the list of all parts on the CW2079CWN, or you can search by name or part description. You can also find your part by where it is located on the CW2079CWN by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for CW2079CWN parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Drain Pump and Motor Assembly

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. Note: Pump casing is not included.


Water Inlet Valve - Hot


Tub Bearing


Tub Bearing

Sold individually.




Tub-to-Pump Drain Hose

This hose has bellows to allow for flexibility during the wash and spin cycles.


Shock Absorber Kit

This kit includes 1 shock absorber and 2 pins.


Door Gasket

Also known as a door boot seal or bellow and comes with a drain hole.





Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Washing maching wouldn't drain

  • Customer: Jorge from Apple Valley, CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 418 of 545 people found this instruction helpful
Removed the top of the washer by removing the 4 back screws and 2 small brackets. Then I removed the front panel, this was actually the hardest part, 2 screws and 8 tabs that you pop out carefully from the top of the panel. I only disconnected the power button and was able to rest the panel on top of the washer. The rest of the washer came apart quickly just... read more

Bellows had developed a small hole

  • Customer: Verle from Malcolm, NE
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Removed the old bellows (2 squeeze hose clamps and one screw adjustable hose clamp) slid on the new one and it was done! read more

Unit would not start up

  • Customer: LES from GAINESVILLE, FL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
Conclusion was that either the control panel or the noise filter (an electrical fuse apparatus)was bad. Disconnected the water line, turned off power, and pulled unit out from cabinets. Determined that voltage was going into the noise filter (white harness) but almost no voltage coming out (red harness). Ordered noise filter. Hardest part was removing old no... read more