CVGX2423B Jenn-Air Cooktop - Instructions

It took longer to figure out how to get the selector cover off than it did to replace the switch. Once I had access it was only about a 10-15 minute job to install and put it all back together and operative. Actually a very easy job to do.

Turned off gas, unscrewed nut that held on the plate unplugged the igniter and replaced it and put it back together, very easy fix.

replace burner cap

Took the old filter out and put a new one in. No tools no fuss no muss. Very easy.

The old grease filter was removed and the entire downdraft was cleaned. The new filter was slipped in. It is so nice to have the old one out. I am so appreciative of finding this part. :-)

the filter fit because the scale in the photo allowed me to choose which one to buy!

I carefully removed the disgusting old filter and took straight to trash. I then used my wet/dry vacuum to clean the rest of the loose debris from the area where the filter area is located. I used a clean, dry cloth to wipe the remainder of the material away and then carefully lowered the clean new filter down into it's new home. So easy, it took longer to type out these directions :)

The aluminum threads on the post (part15) can get stripped very easily. If you cannot tighten down the flat nut the clicking will occur.

Be sure to unplug the unit first. Removing the screws to the control panel, disconnecting the wires, and replacing the switch is the easy part. The threads are plastic where the nut holds the switch in place, and it would not stay tight, but popped loose because of the plastic threads. I added some super glue to the threads and hand tightened. Replace control panel cover, re-plug into outlet.