This is a grease filter, and it works with your range/stove/oven. This part is chrome-colored and measures 16.5 inches long by 9 inches wide. It is made of metal and is intended for use with downdraft...
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
Manufacturer's Number: A145A Replacement element for larger pots is elevated to improve air circulation. For any Jenn-Air Expressions or Designer electric ranges or cartridges. Replaces the standard l...
This radiant element module is for cooktops.
Radiant element module includes the elements, main top, housing and terminal connections to replace an existing module.
Shut off the house circuit b...
First, the Sears repairman diagnosed the switch as broken, and told us that th part, if it were available, would be $150 plus labor. However, he said it was not available, so we'd need to get a new counter top stove all together. Not.
I came to Parts Select, and I found the fan control switch listed here (if you found this st
... Read moreory, you've found the right part). In one day, I had the part in my hand...the part that Sears said didn't exist.
First, I turned off the main fuse switch controlling the stove top! Very important! Then I tried to heat up the elements to verify that the electricity was disconnected. I removed the glass top, then the pan, then removed the side screws that hold the flange in place, the same flange thae holds the knob control area in place. Then I removed the knobs (they just pull right off). Then I removed the knob control area. A small nut holds the fan control switch in place. Remove that, then the switch is loose under the control area. There are 4 wires, but two are connected to each other, so don't panic! Swap them out for your new part, and at this point, very carefully, turn on the main electric again and verify that the switch works. It should.
Turn off the electricity again, then mount the switch up under the control area. There should be a little, bitty tab on the control switch box that fits perfectly into the metal control panel, just to the left of the hole for the stem of the control switch--proof that this switch is meant to be used on this Jenn Air Expressions model CVEX4100/4270/4370 series counter top.
Then reverse the steps to replace all the panels, knobs, pans and elements, and you can cook without smoking up your kitchen, all for thousands less than a brand, new appliance.
Oh, one more thing. The nut around the old switch cannot be used on the new switch. However, you can use a nut from a coaxial cable fitting! It is the same thread count. I used mine from an RCA In Line F Connector 4 pack...part number VH664N.
Lift off blower vent cover. Lift out old filter. Clean walls and bottom of down draft using degrease soap and warm water. Dry. Discovered my grease filter will not install diagonally as shown in unit manual. Decided to drop into downdraft and put in front of fan suction. Found this left a gap at the top of fan suction that was not co
... Read morevered by the filter. Cut piece of wood 1 inch thick and width and length to drop down in the downdraft and lay on bottom. Set filter on top of wood in front of the fan suction. Verified that fan suction would pull filter tight against the opening by turning fan on and off. Put vent cover back over downdraft and told wife I was done.
Our Jenn-Air cook top is 25 years old. One can no longer order parts for this old of model. We ordered new SS burners as well as new Burner cartridge terminal blocks for a new and current model. They work perfectly. Took 10 minutes. $ 350 dollars verses $ 2600 for a new JennAir range plus instillation. Unit looks and works great. Pla
... Read moren to order new switches next.