Models > CTX16APJRAD

CTX16APJRAD General Electric Refrigerator - Overview

Get Parts and Repair Help for CTX16APJRAD

If you know the refrigerator repair part you need, you can browse the list of all parts on the CTX16APJRAD, or you can search by name or part description. You can also find your part by where it is located on the CTX16APJRAD by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for CTX16APJRAD parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CTX16APJRAD [Viewing 3 of 3]

$2.52

Light Bulb - 40W

Sold individually.

$44.55

Crisper Drawer Cover

This cover has the drawer slides built into it.

$137.62

Ice Maker

Replacement icemaker kit - electronic. This kit includes a 4 pin round plug-in connector, 6 post plug-in connector, tube and fill cup.

$19.30

Single Outlet Valve Kit

This single outlet valve has 1/4 inch compression fittings, and is intended for use with refrigerators that have ice makers that make crescent shaped ice cubes. NOTE: As per the manufacturer this valve has new quick connection. You must cut retaining nut off of the current plastic water line and gently push it into new valve. To remove, depress ring that the tube slides into.

$11.93

Package of 12 Screws

$3.00

SWITCH LIGHT

$53.41

Stationary Wire Shelf

$16.66

Door Shelf Retainer Bar End Cap - Left or Right Side

This end cap can be used for the right or left side of the refrigerator door shelf or the freezer door shelf.

$47.63

Defrost Timer

This refrigerator defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are...

$7.95

Compressor Relay

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Vegetable pan cover broke down the middle

  • Customer: Kim from Bronx NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 43 of 45 people found this instruction helpful
When the cover came to my apartment, I crossed my fingers that the piece would fit . Well, within 5 minutes the old cover was out and the new cover in. And it looks better than new! Finally, I don't have to hold my vegetable drawers up with a D battery! read more

ice stalactites were drooling out of the icemaker and gumming up the cubes in the receiving tray.

  • Customer: Gerald from Benicia CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 38 of 40 people found this instruction helpful
I first shut off water flow to the fridge. Examination of the package (which was not exact in appearance to the original) demonstrated that the electrical connectors were well-insulated so I arrogantly and successfully proceded without disconnecting the power. My fridge is old enough that the model doesn't appear exactly on anyone's list so I wasn't alarmed... read more

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 35 of 39 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more