Models > CTL1911GEW

CTL1911GEW Magic Chef Refrigerator - Overview

Get Parts and Repair Help for CTL1911GEW

If you know the refrigerator repair part you need, you can browse the list of all parts on the CTL1911GEW, or you can search by name or part description. You can also find your part by where it is located on the CTL1911GEW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for CTL1911GEW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$2.70

Screw

This screw is sold individually.

$8.27

Shelf Retainer Bar End Cap

Sold individually.

$37.21

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$7.28

Light Rocker Switch

$3.96

Crisper Drawer Shelf Support

This crisper drawer shelf support is used for many refrigerators.

$2.70

Screw

This screw is sold individually.

$55.91

Defrost Timer

This refrigerator defrost timer will cycle for twenty-one minutes after every ten hours of run time. The defrost timer acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

$2.70

SCREW

Sold individually.

$3.96

Lower Hinge Pin

This lower hinge pin is just over an inch long. It is black in color and is made of plastic. It is located on the bottom part of the door hinge.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge would run but not blow cold air. Compressor would cycle for 12 seconds every 5 minutes

  • Customer: Fred from Concord NH
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 40 of 55 people found this instruction helpful
remove back lower panel using nutdriver. Locate and remove Relay and Overload parts from side of Compressor which were located inside a small white box shaped cover unti held on by a spring clip. Attach new Relay and overload to 3 pin terminals on side of compressor. Attach 1 white & 1 orange/white wire to relay terminals. Attach supplied white jumper wire t... read more

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 31 of 38 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Fridge not cooling

  • Customer: Peter from San Jose CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 33 people found this instruction helpful
The fridge wasnt cooling and freezer was barely operating. We had the same problem in 2005 and the fan that blows cold air into the freezer and fridge was replaced for $200 BY Maytag. We looked up the part and found two choices with different connectors but narrowed it down by the pictures and series #. The part was ordered Sunday and arrived Tuesday for ~... read more