Models > CTE18EPFRAD

CTE18EPFRAD Hotpoint Refrigerator - Overview

Get Parts and Repair Help for CTE18EPFRAD

If you know the refrigerator repair part you need, you can browse the list of all parts on the CTE18EPFRAD, or you can search by name or part description. You can also find your part by where it is located on the CTE18EPFRAD by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CTE18EPFRAD [Viewing 3 of 3]

$3.22

SWITCH LIGHT

$67.82

Fresh Food Door Gasket

This fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$16.66

Door Shelf Retainer Bar End Cap - Left or Right Side

This end cap can be used for the right or left side of the refrigerator door shelf or the freezer door shelf.

$2.83

SCR 10-16 AB PNT20 1/2 S

$4.91

Light Socket

$2.06

SCR 8-18 CA HX 1/2 S

$9.96

Evaporator Fan Blade Kit

$137.62

Condenser Fan Motor - 115V

This part comes with 3 round pin connection terminals. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

$17.47

Sheet Metal Screws - 12 per pack

$4.09

Ice Cube Tray

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 39 of 43 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more

Panel hot to touch between freezer & refrigerator. Motor hot, fan not rotating.

  • Customer: Kimberly from Grandy NC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 17 of 21 people found this instruction helpful
Unplugged refrigerator, removed three screws to take out part, disconnected the wires and removed bad unit. Removed fan blade from old unit and attached to the new unit. Attached wires, placed the new motor back in. Plugged it back in, within 20 minutes panel between freezer and refrigerator was cool to touch. read more

it appears some one damaged the gasket in the front

  • Customer: Kah Po from San Francisco CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 15 of 18 people found this instruction helpful
First, I removed the old gasket by ripping it out of front,

Second, I cleansed the rust (no idea how that get there, maybe it's a cheap fridge)

Third, I took some boiling water from the water boiler and dip the new gasket in it to "smooth" out the gasket and make it more "pliable" (really, it didn't seem like much happened, nonetheless... read more