Models > CSK27PFZBWW

CSK27PFZBWW General Electric Refrigerator - Overview

Get Parts and Repair Help for CSK27PFZBWW

If you know the refrigerator repair part you need, you can browse the list of all parts on the CSK27PFZBWW, or you can search by name or part description. You can also find your part by where it is located on the CSK27PFZBWW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for CSK27PFZBWW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$6.20

Dispenser Door Assembly or Flapper

This part mounts in the ice dispenser. **** The crank no longer comes with this part. You can use original crank. The crank is sold separately depending on model number of appli...

$18.07

Drawer Slide Rail - Right Side

$15.92

Drawer Slide Rail - Left Side

When looking inside the fridge, this white drawer slide rail is located on the left side of the refrigerator. Rail ONLY.

$4.21

Bearing Slide

Sold individually.

$3.22

SWITCH LIGHT

$1.70

Screw

This screw is sold individually.

$5.79

Water Tube Union - 5/16" x 5/16"

Sold individually.

$11.93

Package of 12 Screws

$25.41

Defrost Thermostat

This clip on refrigerator defrost thermostat clips on to your refrigerator's evaporator. It will cut out at 60 degrees Fahrenheit and kick back in when the temperature drops to 32 ...

$14.73

Plastic Tubing - 5/16"

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Internal water lines brittle, cracked, leaking

  • Customer: Marty from West Bloomfield MI
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Wrench(Adjustable)
  • 59 of 69 people found this instruction helpful
First of all, the larger white plastic tubes in this thing are 5/16" OD, which no plumbing store seems to stock. At the lower left rear end there are 2 tubes, one for water and one for ice, that are doomed to fail being in proximity of a heat source - they essentially get cooked to the point of becoming brittle and cracking. The smaller tube and union can ... read more

Finish on handles had worn off over the years - they looked awful !

  • Customer: Lynelle from Jacksonville FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 41 of 43 people found this instruction helpful
WIth a flathead screwdriver, I "popped off" the 4 long thin white "cover" strips that run from the top and bottom of the doors to the beginning of the door handles. This exposed the screws that held the old handles in place. Simply remove the old handles, replace with new ones, then replace the "cover strips" . It was very easy and looks so much better. ... read more

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 39 of 43 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more