CSK27PFXBBB Hotpoint Refrigerator - Instructions

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

Ordered both rails to make sure they matched. Unscrewed old broken rail and other side. Screwed on new ones. Real easy and perfect fit. Unfortunately I didn't notice crack in drawer until then, so had to order it. Both ordered arrived in only a day or two and had the refrigerator back up and working easily.

put in two screws"very easy!!!

What a snap. I was so proud of myself, kept sliding the drawer in and out after the slide rail was installed. I thought I never would be able to fix it and I'm so glad ge had the piece that would fit into this older model refrigerator.

Snapped off the plastic plate covering the dispenser. Removed the four screws holding the mechanism in place. Remove the electrical connections. Pull the mechanism out and up carefully pulling the dispenser pad out with all the mechanism in place. Look at the mechanism before removing any parts to get a mental image so that reassembly will be easy. Remove any electrical switch or circuit boards and remove old parts before submerging the mechanism in hot soapy water for clean-up. The Clean-up will take longer than the disassemble and reassembling. After completion the dispenser works as it should.

Pulled out old actuator pad worked the control for several minutes to free up the mechanism to make sure water would turn off. Then installed the new actuator pad.

The longest part was emptying the door for removal. Remove screw on top of hinge, have someone hold the door while I removed the hinge bolts, unplug door from fridge, then remove the door. Then just put the cam-riser where the old one was and put the door back on. Easy as pie.

Connected the 2 wires and pushed in the switch until it clicked.

Followed on line instructions. No problems.

Very Easy, follow direction I the video.

per your instructions

This has been a problem for some time and had I known how simple it was to repair, I would have done it a long time ago. I followed the online instruction provided and had it done in under 15 minutes! I removed the upper drawer and shelf, the middle drawer and glass shelf, unscrewed the 2 screws holding the broken slide rail to the side of the refrigerator, applied the new slide rail in place of the old, replaced the glass shelves and drawers and that was it! Works like a charm!

The hardest part was getting hte right replacement drawer.

Pull out old pan,remove the vent cover from front and install it on the new pan, done.

Had to take front panel off dispenser area. Then remove components and install new part. That was easy part. Problem was getting components back into front of freezer. Seemed like something was blocking it from going all the way in. Had to remove small amount of insulation and "jiggle" components and eventually fell into place.