CSH22GRXAWW Hotpoint Refrigerator - Instructions

Repair was really easy, bought the part because of partselect video. Saved myself a lot of money vs calling a repairman.

Turned the appliance off, take the back panel off, defrosted the coils. Put a cork in the drain hole and a towel to soak up the water. Four screws take the heaters off, pull the thermostat from the top coil. Unplug the wire at the top. Install the new heaters, clip the thermostat on the top coil, route the wires around the side, plug in the heaters. Put the panel back on with four screws, turn the appliance back on. You may need to empty the ice container because it will thaw some and freeze back solid. Most of the time spent defrosting the coils

Followed the instructions. Smooth as silk. This part is better than the original. There appears to be a sensor that beeps when the ice reservoir is full.

Part came in on time, and the repair went smoothly - no problems

I followed the instructions on the youtube video on the company web page. I removed the cover by hand, removed the exisitng flapper door and install the new door, easy as pie.

turned water off removed old water valve moved wires to new one moved water supply and discharges to new one reinstalled new valve

Followed easy video instructions. Loosened the necessary bolts, etc. Replaced hinge assembly, lined up door, lubed the hinge with vasoline. Works perfectly now. May purchase another assembly as spare as it appears this may be a common repair issue.

Took the paper clip, pressed in through the holes on the bottom of the ice dispenser panel. Removed the four screws. Loosened the panel and removed the wires. replaced the flapper door. Then reversed the process. Your video was VERY helpful except for the paper clip. Had to get that off another web site.

I used the how to video from the site and had the part replaced in about the same time the video did it, even with being distracted with a phone call.

Removed the old broken one with screw driver and installed new one with screw driver and voila all done!

did it just as the video showed. it was a little different, but absolutely nothing that we as ametures could not figure out! very easy and I think it was just the part we needed! biggest thing was unloading refrigerator!

I followed your terrific video. I first got all tools ready, covered a table in cardboard, and removed food from the fridge door. I removed the cap and screws on top of the door hinge. Lifting the door off was simple, and after laying the door on the table, the retaining screw was easily loosened, and the cam screw removed. The only problem was that half the thin gasket under the broken cam was missing. No new gasket came with the part. I wanted the new cam to lay flat, so I made a partial gasket from a matchbook cover and filled the gap. It all went back together quickly. Just have tools ready beforehand. Ten minute job, unless you have to make a new gasket or part of one. Thanks, guys.

I spent 15 - 20 minutes just hunting/deciding which of several sets of parts & directions to follow. The provided directions were not bad; but none of them quite matched my GE ADORA side-by-side model. Once I came up with the actions I would need to take...I was done in 5 minutes! The kit , as I said, came with all the parts one could need (and one or two un-needed parts included for other model GE refrigerators) I am very happy with PART SELECT...altough GE doesn't rate as high with me for their declining reliability.

1. Watched the video on how to make the repair. 2. Used the tools recommended. 3. Followed easy instructions as demonstrated on video, and Viola! It was repaired.

I have never repaired anything before but I found your web site ordered the item and received it in 2 days Thank You,thank you