CSH22GRTAWW Hotpoint Refrigerator - Instructions

Empty door first then take a phillip heads screw driver and unscrewed the top hinge cover 1 screw. Then used 5/16 nut driver to loosen top hinge from fridge. remove door by lifting and then lay on table to replace the lower washer that is held in by 2 screws and you only need to loosen one all the way leaving one in to align then replace and tighten it up your done.

Followed the video, very simple

Watched the video supplied by manufacturer and followed the instructions. Very easy.

I watched the video on the partselect website once and completed the repair. Very easy!

I followed the instructions of the other DIY selfers wrote on how they took it apart and put it back together. Only thing that took longer was melting the ice. Other than that they gave good instructions. Had it out and back in within 10 maybe 15 mins. most. Have a brand new fridge, probably could last me another 18 years.

The trim piece covering the opening of the dispenser is the first and most difficult part of the disassembly. Take care when removing this piece that it does not break.

Followed Partselect video on how to replace cam riser. Very, very helpful!

just i took off the actuator and replace with the new one in 8 minutes.It was so easy.

when I got on your site I was able to find the part easily & your installation video was a big help. It fit perfectly & was very easy to install--it's working great!!!!!thank you so much

I watched the you tube video. Very easy! the part was easy to order came earlier that expected and was fixed in less than 5 minutes!

Unscrew 2 screws to remove broken part, screw in new.

First, depending on when you find out your problem, be prepared to toss out spoiled food. Unplug the unit. Since you must allow the ice build up on the coil to melt, be prepared for water. Use towels placed under the coil in the freezer to soak this up or it will end up on the floor. Remove ice maker bucket as the ice will melt, that is if there is any. In my case the defrost timer was bad but I later learned that my defrost heater was also bad. Do yourself a favor and change both the defrost timer and defrost heaters. This issue is generally an age issue so replacing both will give you peace of mind. Also, clean the whole freezer as this is the time to do it. You will be surprised at the ice maker bucket cleanliness. Time to prepare and clean is what takes additional time. Time to repair is short and simple. One last thing, when replacing the defrost timer try not to mess with the temp. control slides as you will have to put them back in the proper positions for reassembly of the cover.

Ordered part on line, arrived the next day. Looked at the screw (phillips head). Had trouble dropping screws but got our magnetic phillips head and it worked like a charm. So proud of myself as my husband did not have to do a thing.

Solenoid pushing the crushed ice flapper was burned out. Solenoid was easy to find unplug and replace. I used the old piston which simplified things. Now works great

Ordered this part after i replaced the plastic tubes on the back as the problem persisted. loosen the nuts holding the water inlet lines, remove the cover to the valve. remove the valve and the water inlet line to the the valve. Disconnect the 2 outlets from the valve. 1 outlet to icemaker and other outlet to water cooler (bigger). Connect water inlet and 2 outlets to the new valve, test the water lines. Found the inlet is leaking, removed it and added teflon tape and reconnect it. All is done. Then I left the freezer door open for 3 hours to melt the ice on the wrong places and all is well.