Models > CSG9000CAB

CSG9000CAB Maytag Cooktop - Overview

Get Parts and Repair Help for CSG9000CAB

If you know the cooktop repair part you need, you can browse the list of all parts on the CSG9000CAB, or you can search by name or part description. You can also find your part by where it is located on the CSG9000CAB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CSG9000CAB [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$22.97

Burner Head Cap with Spark Electrode

This part has been redesigned and no longer requires a gasket seal.

$2.70

Screw

This screw is sold individually.

$4.60

SCREW

$3.71

Igniter Wire

$25.79

Surface Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

$50.84

Burner Grate

$39.15

Burner Switch

Order quantity required.

$2.70

Washer

$80.04

Burner Valve

PIPE, MANIFOLD

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner wouldn't start

  • Customer: Yury from Brooklyn NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 14 of 22 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

burner head was rusted out. ordered 1 to see if part was correct. ordered 4 more to finish job.

  • Customer: Robert from Somerville TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 6 of 7 people found this instruction helpful
unscrewed old burner head ;disconnected 2 wires; repaced with new burner head and replaced wires. Unfortunately, before we really needed to replace the other burner heads, the cooktop itself developed a gas leak. We decided to replace the whole thing, and therefore would like to return the unboxed, unused 4 remaining burner heads. read more

burners and drip pans rusted through

  • Customer: Gordon from Deville LA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 11 people found this instruction helpful
I first had to cut off electrical power to the stove top and then remove a little built up grease around the seams where the parts fit together. I then removed the burner head by twisting about 30 degrees and lifting. I then disconnected the spark ignighter wire, ( a slide on spade). This exposed the two screws that hold the drip pan in place. I had to use... read more