Models > CSG5600CAD

CSG5600CAD Maytag Cooktop - Overview

Get Parts and Repair Help for CSG5600CAD

If you know the cooktop repair part you need, you can browse the list of all parts on the CSG5600CAD, or you can search by name or part description. You can also find your part by where it is located on the CSG5600CAD by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for CSG5600CAD parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CSG5600CAD [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.78

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$22.97

Burner Head Cap with Spark Electrode

This part has been redesigned and no longer requires a gasket seal.

$2.70

Screw

This screw is sold individually.

$3.71

Igniter Wire

$39.15

Burner Switch

Order quantity required.

$53.63

GRATE-BRNR

PIPE, MANIFOLD

$89.94

REGULATOR-

$25.49

Burner Foam Tape

$18.04

Power Cord

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burner ignitor failure

  • Customer: roy from East Providence RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 52 of 59 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more

Burner wouldn't start

  • Customer: Yury from Brooklyn NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 14 of 22 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

burner would not light; ignitor did not produce spark

  • Customer: Candace L. from Woodinville WA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 10 people found this instruction helpful
Take a few screws off the back of the slide in burner module. Take off the back. Unscrew the ignitor screw, remove ignitor carefully, replace with the new ignitor, put the screw back in, put the back back on, try it out! Ours worked after a couple of tries - don't know if the ignitor had to "rev up" by several sparks or we just didn't have it properly ins... read more