Models > CSG5600BAW

CSG5600BAW Maytag Cooktop - Overview

Get Parts and Repair Help for CSG5600BAW

If you know the cooktop repair part you need, you can browse the list of all parts on the CSG5600BAW, or you can search by name or part description. You can also find your part by where it is located on the CSG5600BAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CSG5600BAW [Viewing 2 of 2]

$28.71

Burner Head Cap with Spark Electrode

This part has been redesigned and no longer requires a gasket seal.

$2.70

Screw

This screw is sold individually.

$4.60

SCREW

$3.71

Igniter Wire

SCREW

$93.95

USE WPL 74006282

$38.31

Burner Spark Ignition Switch

$21.09

Power Cord

$3.83

SCREW

$51.03

Square Burner Grate - Black

Sold individually

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner wouldn't start

  • Customer: Yury from Brooklyn NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 14 of 22 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

burner head was rusted out. ordered 1 to see if part was correct. ordered 4 more to finish job.

  • Customer: Robert from Somerville TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 6 of 7 people found this instruction helpful
unscrewed old burner head ;disconnected 2 wires; repaced with new burner head and replaced wires. Unfortunately, before we really needed to replace the other burner heads, the cooktop itself developed a gas leak. We decided to replace the whole thing, and therefore would like to return the unboxed, unused 4 remaining burner heads. read more

Igniter Switch on the burner was constantly on

  • Customer: Roman from West Caldwell NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 4 of 9 people found this instruction helpful
To get to the switch I had to remove the knobs and the front panel of the burner valves. There were some dozen screws, top and bottom holding the panel in-place.
The switch slid off the burner valve stem easily but removing the wires I had to pull with the pliers. There seamed not to be a wire release that I could see.
Replacing the wires was no p... read more