Models
>
CSF22KPC
CSF22KPC Hotpoint Refrigerator - Overview
Sections of the CSF22KPC
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Evaporator Fan Blade Kit
PartSelect #: PS304684
Manufacturer #: WR60X114
This kit features a 5-blade plastic evaporator fan blade that rotates CCW and measures 4.5-inches in diameter and has a 3/8-inch-tall shaft. This kit also has a metal compression ring that secures the...
$26.55
In Stock
Condenser Fan Motor
PartSelect #: PS304722
Manufacturer #: WR60X177
This condenser fan motor operates in a clockwise fashion. The fan itself has two 1/4 inch spade terminals. It carries 2 watts and 115 volts. This motor NO longer comes with cover for terminals.
$198.31
In Stock
Defrost Thermostat
PartSelect #: PS303547
Manufacturer #: WR50X60
This refrigerator defrost thermostat will cut out at 60 degrees Fahrenheit and kick back in when the temperature drops to 40 degrees Fahrenheit. Use it for your GE brand refrigerator.
$22.09
In Stock
Defrost Timer
PartSelect #: PS310849
Manufacturer #: WR9X480
This refrigerator defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, but its terminals are bent and the leads are external.
$43.92
In Stock
Heater and Bracket Kit
PartSelect #: PS303264
Manufacturer #: WR49X391
NOTE: This it is just the heaters and the jumper wires between the two heaters.
No Longer Available
Evaporator Fan Motor
PartSelect #: PS304708
Manufacturer #: WR60X162
This evaporator fan motor operates in a counter clockwise fashion. This motor's stack is 3/8 of an inch, and the motor has two terminals: one on the right side, and one on the left side. Use this evap...
$75.49
In Stock
Single Water Valve
PartSelect #: PS304416
Manufacturer #: WR57X77
This single outlet valve comes with a gasket, and is intended for refrigerators that have ice makers which make round ice cubes. If the ice maker is still not working properly, the issue could be that...
No Longer Available
Fresh Food Door Gasket
PartSelect #: PS296859
Manufacturer #: WR24X246
This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.
$171.40
Special Order
Ice Maker Seal Kit
PartSelect #: PS297351
Manufacturer #: WR29X144
This newly redesigned icemaker seal kit comes with a new shaft, seal and screw.
No Longer Available
Cut to Fit Door Gasket Kit - Gray
PartSelect #: PS296958
Manufacturer #: WR24X433
This gray door gasket kit is cut to fit your refrigerator, though some assembly is required. Use it for your GE brand refrigerator.
No Longer Available
Questions And Answers for CSF22KPC
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the CSF22KPC
[Viewing 3 of 3]Noisy
Fixed by
these parts
these parts
Show All
Fridge too warm
Fixed by
these parts
these parts
Show All
Freezer section too warm
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Wouldn't cool
I removed the 3 screws that held the motor and fan. Exchanged fan blades and reinstalled the fan and new motor
I was surprised to find the motor. The refrigerator/freezer was over 28 yrs old. Works fine now
I was surprised to find the motor. The refrigerator/freezer was over 28 yrs old. Works fine now
Parts Used:
-
Clarence from Great Cacapon, WV
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Socket set
16 of 22 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Noisy Fan Motor - Bearing went out.
Moving the frig out and cleaning was the hardest part of this job - lots of dust collected over the 17 years the frig was in place. Once all the cleaning was done, with the frig out and back cover off (10 -12 screws taken off with nutdriver),I plugged the frig in and observed the the problem was a noisy fan motor. The motor is at the very
... Read more
back of the frig with easy access to the 3 brackets holding it in place.
Pull off the electrical clip. Remove the screw holding the bracket to the frame on the front bracket, leaving the bracket attacked to the fan. The other two screws remove from the fan, leaving the brackets in place.
Reverse the procedure when you receive the new part from PartSelect(great company to deal with)!
Pull off the electrical clip. Remove the screw holding the bracket to the frame on the front bracket, leaving the bracket attacked to the fan. The other two screws remove from the fan, leaving the brackets in place.
Reverse the procedure when you receive the new part from PartSelect(great company to deal with)!
Read less
Parts Used:
-
Robert from Carpinteria, CA
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver
11 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refridgerator was running constantly and condesor would get very hot, condesor fan would only turn on if I spun it.
Unplugged fridge removed the three screws that held fan on to fan frame unplugged condensor fan removed brackets from old fan and put them on new fan installed new fan plugged in fridge and now it works great!
Parts Used:
-
Raymond from Los Lunas, NM
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Socket set
8 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!